May 2003
LMH6642/6643/6644
3V, Low Power, 130MHz, 75mA Rail-to-Rail Output
Amplifiers
in single (LMH6642), dual (LMH6643), and quad (LMH6644)
options. See ordering information for packages offered.
General Description
The LMH664X family true single supply voltage feedback
amplifiers offer high speed (130MHz), low distortion
(−62dBc), and exceptionally high output current (approxi-
mately 75mA) at low cost and with reduced power consump-
tion when compared against existing devices with similar
performance.
Features
(VS
=
5V, TA = 25˚C, RL = 2kΩ, AV = +1. Typical values
unless specified).
n −3dB BW (AV = +1)
130MHz
3V to 12.8V
130V/µs
Input common mode voltage range extends to 0.5V below V−
and 1V from V+. Output voltage range extends to within
40mV of either supply rail, allowing wide dynamic range
especially desirable in low voltage applications. The output
stage is capable of approximately 75mA in order to drive
heavy loads. Fast output Slew Rate (130V/µs) ensures large
peak-to-peak output swings can be maintained even at
higher speeds, resulting in exceptional full power bandwidth
of 40MHz with a 3V supply. These characteristics, along with
low cost, are ideal features for a multitude of industrial and
commercial applications.
n Supply voltage range
n Slew rate (Note 8), (AV = −1)
n Supply current (no load)
n Output short circuit current
n Linear output current
2.7mA/amp
+115mA/−145mA
75mA
n Input common mode volt. 0.5V beyond V−, 1V from V+
n Output voltage swing
n Input voltage noise (100kHz)
n Input current noise (100kHz)
40mV from rails
17nV/
0.9pA/
n THD (5MHz, RL = 2kΩ, VO = 2VPP, AV = +2)
n Settling time
−62dBc
68ns
Careful attention has been paid to ensure device stability
under all operating voltages and modes. The result is a very
well behaved frequency response characteristic (0.1dB gain
flatness up the 12MHz under 150Ω load and AV = +2) with
minimal peaking (typically 2dB maximum) for any gain set-
ting and under both heavy and light loads. This along with
fast settling time (68ns) and low distortion allows the device
to operate well in ADC buffer, and high frequency filter
applications as well as other applications.
n Fully characterized for 3V, 5V, and 5V
n Overdrive recovery
100ns
n Output short circuit protected (Note 11)
n No output phase reversal with CMVR exceeded
Applications
n Active filters
n CD/DVD ROM
n ADC buffer amp
n Portable video
n Current sense buffer
This device family offers professional quality video perfor-
mance with low DG (0.01%) and DP (0.01˚) characteristics.
Differential Gain and Differential Phase characteristics are
also well maintained under heavy loads (150Ω) and through-
out the output voltage range. The LMH664X family is offered
Closed Loop Gain vs. Frequency for Various Gain
Large Signal Frequency Response
20018547
20018535
© 2003 National Semiconductor Corporation
DS200185
www.national.com