LM25149
SNVSBV5 – DECELMMBE2R52104290
SNVSBV5 – DECEMBER 2020
www.ti.com
LM25149 42-V Synchronous Buck DC/DC Controller with Ultra-Low IQ and Integrated
Active EMI Filter
1 Features
2 Applications
•
Two integrated EMI mitigation mechanisms
– Active EMI filter for enhanced EMI performance
at lower frequencies
•
•
•
Building automation
Industrial transport
Wireless infrastructure
– Dual random spread spectrum (DRSS) for
enhanced EMI performance across low and
high-frequency bands
3 Description
The LM25149 is a 42-V synchronous buck DC/DC
controller for high-current single-output applications.
Refer to the Errata. The device uses peak current-
– EMI reduced by an average of 25 dBµV
– Reduces the external differential-mode filter
size by 50% and lowers systems cost
Versatile synchronous buck DC/DC controller
– Wide input voltage range of 3.5 V to 42 V
– 1% accurate, fixed 3.3-V, 5-V, 12-V, or
adjustable outputs from 0.8 V to 36 V
– 150°C maximum junction temperature
– Shutdown mode current: 2.2 µA
mode
control
architecture
for
easy
loop
compensation, fast transient response, and excellent
load and line regulation. The LM25149 can be set up
in interleaved mode (paralleled output) with accurate
current sharing for high-current applications. The
LM25149 can operate at input voltages as low as 3.5
V, at nearly 100% duty cycle if needed.
•
The LM25149 has two unique EMI reduction features:
active EMI Filter and Dual Random Spread Spectrum
(DRSS). Active EMI filter senses any noise or ripple
voltage on the DC input bus and injects an out-of-
phase cancellation signal to reduce the noise or ripple
voltage. DRSS combines a low-frequency triangular
and high-frequency random modulation to optimize
EMI preformance in the low-frequency and high-
frequency radio frequency bands.
– No-load standby current: 9 µA
•
•
Switching frequency from 100 kHz to 2.2 MHz
– SYNC in and SYNC out capability
Inherent protection features for robust design
– Internal hiccup-mode overcurrent protection
– ENABLE and PGOOD functions
– VCC, VDDA, and gate-drive UVLO protection
– Internal or external loop compensation
– Thermal shutdown protection with hysteresis
Create a custom design using the LM25149 with
WEBENCH® Power Designer
Device Information
PART NUMBER
PACKAGE(1)
BODY SIZE (NOM)
•
LM25149
VQFN (24)
3.5 mm × 5.5 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet
CISPR 25 Class 5 Peak
Peak
Average
Start 150 kHz
Stop 30 MHz
CISPR 25 Class 5 Average
Typical Application Schematic
CISPR 25 EMI Performance 150 kHz ̶ 30 MHz
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
Copyright © 2020 Texas Instruments Incorporated
Submit Document Feedback
intellectual property matters and other important disclaimers. ADVANCE INFORMATION for preproduction products; subject to change
Product Folder Links: LM25149
1
without notice.