LM3658
www.ti.com
SNVS328E –MAY 2005–REVISED MARCH 2007
LM3658 Dual Source USB/AC Li Chemistry Charger IC for Portable Applications
Check for Samples: LM3658
1
FEATURES
DESCRIPTION
The LM3658 is a single chip charger IC designed for
handheld applications. It can safely charge and
maintain a single cell Li-Ion/Polymer battery operating
from an AC wall adapter or USB power source. Input
power source selection of USB/AC is automatic. With
both power sources present, the AC power source
has priority. Charge current is programmed through
an external resistor when operating from an AC wall
adapter allowing charge currents from 50 mA to 1000
mA. When the battery is charged using USB power,
charge currents of 100 mA or 500 mA are pin-
selectable. The termination voltage is controlled to
within ±0.35% of 4.2V.
2
•
Integrated Power FETs with Thermal
Regulation
•
Charges from Either an AC Wall Adapter or
USB Power Source with Automatic Source
Selection
•
•
•
50 mA to 1000 mA Charge Currents Using AC
Wall Adapter
Pin-Selectable USB Charge Currents of 100
mA or 500 mA
LDO Mode with 1A of Source Current is
Automatically Invoked When the Battery is
Absent and the AC Wall Adapter is Connected
The LM3658 requires few external components and
integrates internal power FETs, reverse current
protection and current sensing. The internal power
FETs are thermally regulated to obtain the most
•
•
•
•
Continuous Battery Temperature Monitoring
Built-in Multiple Safety Timers
Charge Status Indication
efficient charging rate for
temperature.
a
given ambient
Continuous Over-current and Temperature
Protection
The LM3658 operates in five modes: pre-qualification
mode, constant-current mode, constant-voltage
mode, top-off mode and maintenance mode.
Additionally, the charger IC operates as a linear
regulator in “LDO mode”, when the AC wall adapter is
connected and no battery is present. Optimal battery
management is obtained through thermal regulation,
battery temperature measurement and multiple safety
timers. The LM3658 provides two open-drain outputs
for LED status indication or connection to GPIOs.
•
•
•
Near-depleted Battery Pre-conditioning
Sleep Mode with Ultra Low Quiescent Current
On-board Kelvin-sensing Achieves ±0.35%
Termination Accuracy
•
•
Maintenance Mode with Automatic Recharge
Thermally Enhanced 3 mm x 3 mm WSON
Package
APPLICATIONS
Typical Application
•
•
•
•
•
Smartphones
CHG_IN
4.5V to 6V
Digital Still Cameras
PDAs
1
BATT
1 mF
10
1 mF
1 mF
+
Battery
Pack
Hard Drive and Flash-based MP3 Players
USB-powered Devices
USBpwr
4.5V to 6V
2
Ts
9
LM3658
Iset
GND
3
4
5
8
7
6
USB_sel
EN_b
Stat1
Stat2
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
All trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2005–2007, Texas Instruments Incorporated