LM2575
1.0 A, Adjustable Output
Voltage, Step-Down
Switching Regulator
The LM2575 series of regulators are monolithic integrated circuits
ideally suited for easy and convenient design of a step–down
switching regulator (buck converter). All circuits of this series are
capable of driving a 1.0 A load with excellent line and load regulation.
These devices are available in fixed output voltages of 3.3 V, 5.0 V,
12 V, 15 V, and an adjustable output version.
These regulators were designed to minimize the number of external
components to simplify the power supply design. Standard series of
inductors optimized for use with the LM2575 are offered by several
different inductor manufacturers.
http://onsemi.com
TO–220
TV SUFFIX
CASE 314B
1
5
Heatsink surface connected to Pin 3
Since the LM2575 converter is a switch–mode power supply, its
efficiency is significantly higher in comparison with popular
three–terminal linear regulators, especially with higher input voltages.
In many cases, the power dissipated by the LM2575 regulator is so
low, that no heatsink is required or its size could be reduced
dramatically.
TO–220
T SUFFIX
CASE 314D
1
The LM2575 features include a guaranteed ±4% tolerance on output
voltage within specified input voltages and output load conditions, and
±10% on the oscillator frequency (±2% over 0°C to 125°C). External
shutdown is included, featuring 80 µA typical standby current. The
output switch includes cycle–by–cycle current limiting, as well as
thermal shutdown for full protection under fault conditions.
5
Pin 1.
V
in
2. Output
3. Ground
4. Feedback
5. ON/OFF
Features
• 3.3 V, 5.0 V, 12 V, 15 V, and Adjustable Output Versions
• Adjustable Version Output Voltage Range of 1.23 V to 37 V ±4%
Maximum Over Line and Load Conditions
2
D PAK
D2T SUFFIX
CASE 936A
1
• Guaranteed 1.0 A Output Current
5
• Wide Input Voltage Range: 4.75 V to 40 V
• Requires Only 4 External Components
• 52 kHz Fixed Frequency Internal Oscillator
• TTL Shutdown Capability, Low Power Standby Mode
• High Efficiency
Heatsink surface (shown as terminal 6 in
case outline drawing) is connected to Pin 3
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 24 of this data sheet.
• Uses Readily Available Standard Inductors
• Thermal Shutdown and Current Limit Protection
• Moisture Sensitivity Level (MSL) Equals 1
DEVICE MARKING INFORMATION
See general marking information in the device marking
section on page 24 of this data sheet.
Applications
• Simple and High–Efficiency Step–Down (Buck) Regulators
• Efficient Pre–Regulator for Linear Regulators
• On–Card Switching Regulators
• Positive to Negative Converters (Buck–Boost)
• Negative Step–Up Converters
• Power Supply for Battery Chargers
Semiconductor Components Industries, LLC, 2002
1
Publication Order Number:
January, 2002 – Rev. 4
LM2575/D