LB05S THRU LB10S
MINIATURE GLASS PASSIVATED SINGLE-PHASE SURFACE MOUNT BRIDGE RECTIFIER
REVERSE VOLTAGE: 50 to 1000 VOLTS
FORWARD CURRENT: 0.5 AMPERE
LBXS
FEATURES
· Surge overload rating: 30 amperes peak
· Ideal for printed circuit board
· Plastic material has Underwriters Laboratory
Flammability Classification 94V-0
· Low leakage
· Reliable low cost construction utilizing molded
MECHANICAL DATA
Case: Molded plastic, LBXS
Epoxy: UL 94V-O rate flame retardant
Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed
Dimensions in inches and (millimeters)
Mounting position: Any
Weight: 0.00528ounce, 0.134gram
Maximum Ratings and Electrical Characteristics
Ratings at 25℃ ambient temperature unless otherwise specified.
Single phase, half wave, 60HZ, resistive or inductive load.
LB05S
50
LB1S
100
70
LB2S
200
140
200
LB4S
400
280
400
LB6S
600
420
600
LB8S
800
560
800
LB10S
1000
700
Units
Volts
Volts
Volts
VRRM
VRMS
VDC
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
35
Maximum DC Blocking Voltage
50
100
1000
Maximum Average Forward Rectified Current
I(AV)
Amp
Amp
on glass-epoxy P.C.B (Note 2)
on aluminum substrate (Note 3)
0.5
0.8
(see Fig. 1)
Peak Forward Surge Current,
8.3ms single half-sine-wave
IFSM
30
superimposed on rated load (JEDEC method)
Maximum Forward Voltage
at 0.4A DC and 25℃
VF
IR
Volts
1.0
at TA=25℃
TA=125℃
5.0
Maximum Reverse Current
at Rated DC Blocking Voltage
uAmp
500
CJ
RθJA
13
60
Typical Junction Capacitance (Note 1)
Typical Thermal Resistance (Note 3)
Typical Thermal Resistance (Note 2)
Operating and Storage Temperature Range
pF
℃/W
℃/W
℃
RθJL
16
-55 to +150
TJ,Tstg
NOTES:
1- Measured at 1 MHZ and applied reverse voltage of 4.0 VDC.
2- On glass epoxy P.C.B. mounted on 0.05 x 0.05" (1.3 x 1.3mm) pads
3- On aluminum substrate P.C.B. with an area of 0.8" x 0.8" (20 x 20mm) mounted on 0.05 x 0.05" (1.3 x 1.3mm) solder pad
MDD ELECTRONICS