Ordering number:ENN2660B
Monolithic Linear IC
LA4460N, 4461N
12W AF Power Amplifier
for Car Radio, Car Stereo
Features
Package Dimensions
unit:mm
• High gain of 51dB typ. and high power output of 12W
typ.
3024A-SIP10H
• Possible to delete output and bootstrap capacitors, this
encourages cost and space reductions due to external parts
reduction.
[LA4460N, 4461N]
4.0
27.0
20.0
• Reduced external components (8 pieces recommended, 6
pieces minimum).
• Almost no pop noises heard during power on or off op-
eration.
• Soft tonal quality in saturated power output.
• Low distortion over low to high ranges of the audio fre-
quencies.
• Low residual noises (Rg=0).
• Good operation conditions because of SIP (single ended
pins) package having been employed for the LA4460N.
• All pin terminal layouts of the LA4461N are reversed for
easy stereo PC board pattern arrengement.
• Two ground terminals for pre-amplifier and power ampli-
fier are provided for easy PC board pattern arrangement
and for stabilizing distortion chracteristics depending on
signal source impedance.
1
10
1.4
2.54
0.4
2.0
0.5
2.07
SANYO : SIP10H
• Voltage gain is fixed at 51dB, however, lowering the gain
is possible by adding a resistor.
• IC is not damaged, if it is connected reversely.
• Audio muting functions (AC mute & DC mute) are
equipped.
• Several protection circuits are installed, including :
a. Thermal protection circuit.
b. Overvoltage & surge voltage protection circuit.
c. Load short-circuit current limiting protection circuit.
d. Output pins DC short-circuit protection circuit.
(grounding protection between OUT & GND, and
speaker protection provided.)
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges,or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
21500TN (KT)/90196RM/D187KI, TS No.2660–1/12