KLI-8023
Linear CCD Image Sensor
Description
The KLI−8023 Image Sensor is a multispectral, linear solid state
image sensor for color scanning applications where ultra-high
resolution is required.
www.onsemi.com
The imager consists of three parallel linear photodiode arrays, each
with 8,000 active photosites for the output of red, green, and blue
(R, G, B) signals. This device offers high sensitivity, high data rates,
low noise and negligible lag. Individual electronic exposure control
for each color allows the KLI−8023 sensor to be used under a variety
of illumination conditions. The imager can be operated in an Extended
Dynamic Range mode for the most demanding applications.
Table 1. GENERAL SPECIFICATIONS
Parameter
Architecture
Typical Value
3 Channel, RGB Trilinear CCD
8002 × 3
Figure 1. KLI−8023 Linear CCD
Image Sensor
Pixel Count
Pixel Size
9 mm (H) × 9 mm (V)
9 mm
Features
Pixel Pitch
• 12 Line Spacing between Color Channels
• Single Shift Register per Channel
• High Off-Band Spectral Rejection
• Dark Reference Pixels Provided
• Anti-Reflective Glass
• Wide Dynamic Range, Low Noise
• Dual Dynamic Range Mode Operation
• No Image Lag
• Electronic Exposure Control
• High Charge Transfer Efficiency
• Two-Phase Register Clocking
• 74 ACT Logic Compatible Clocks
• 6 MHz Maximum Data Rate
Inter-Array Spacing
Imager Size
108 mm (12 Lines Effective)
72.0 mm (H) × 0.225 mm (V)
−
−
Saturation Signal
185 ke (Normal DR Mode)
400 ke (Extended DR Mode)
Dynamic Range
(2 MHz Data Rate)
84 dB (Normal DR Mode)
90 dB (Extended DR Mode)
Responsivity
R, G, B (−RAA)
R, G, B (−DAA)
Mono (−AAA, −SAA, −MAA)
2
32, 20, 20 V/mJ/cm
2
29, 19, 18 V/mJ/cm
2
33 V/mJ/cm
−
Output Sensitivity
Dark Current
14.4 mV/e
0.002 pA/Pixel
8°C
Dark Current Doubling Rate
Charge Transfer Efficiency
Photoresponse Non-Uniformity
Lag (First Field)
0.999998/Transfer
3% Peak-Peak
0.025%
Applications
• Digitization
• Medical Imaging
• Photography
Maximum Data Rate
Package
6 MHz/Channel
CERDIP (Sidebrazed, CuW)
AR Coated, 2 Sides
Cover Glass
ORDERING INFORMATION
See detailed ordering and shipping information on page 2 of
this data sheet.
NOTE: Parameters above are specified at T = 25°C (junction temperature)
and 1 MHz clock rates unless otherwise noted.
© Semiconductor Components Industries, LLC, 2015
1
Publication Order Number:
March, 2017 − Rev. 3
KLI−8023/D