MODEL: JFR2
Plug-in Signal Conditioners M-UNIT
INPUT – Field-selectable
Open collector
Mechanical contact
Voltage pulse
FREQUENCY SCALER
(field-programmable; built-in excitation)
Two-wire current pulse
RS-422 line driver pulse
Functions & Features
• Scales input frequency
• Various outputs (open collector, voltage pulse, Noncontact
AC/DC switch, RS-422 line driver)
• Built-in excitation
[1] EXCITATION
1: 5 V DC @ 120 mA
4: 12 V DC @ 60 mA
7: 24 V DC @ 25 mA
• Scaling factor is user-programmable by simply setting
input and output frequencies via handheld programmer
PU-2x
• Isolation up to 2000 V AC
[2] OUTPUT
A: Open collector (max. 10 kHz)
Typical Applications
M: 5V pulse (max. 10 kHz)
• Scaling frequency signals from a rotary encoder
N: 12 V pulse (max. 10 kHz)
P: 24 V pulse (max. 10 kHz)
J: RS-422 line driver pulse (max. 10 kHz)
R: Noncontact AC/DC switch (max. 20 Hz)
( ) = Max. frequency
50
(1.97)
80
(3.15)
[3] OUTPUT PULSE WIDTH
1: No conversion to one-shot
127
(5)
3: One-shot output (std. pulse width 400 μsec. (20 msec. for output signal R))
(Specify when optional pulse width is required.)
mm (inch)
[4] POWER INPUT
AC Power
MODEL: JFR2–[1][2][3]–[4][5]
K: 85 – 132 V AC
DC Power
ORDERING INFORMATION
• Code number: JFR2-[1][2][3]-[4][5]
S: 12 V DC
Specify a code from below for each of [1] through [5].
(e.g. JFR2-4P1-K/Q)
R: 24 V DC
V: 48 V DC
• Use Ordering Information Sheet (No. ESU-1581). Default
setting (table below) will be used if not otherwise specified.
• Specify the specification for option code /Q
P: 110 V DC
[5] OPTIONS
blank: none
(e.g. /C01/S01)
Factory default setting
/Q: With options (specify the specification)
PARAMETER
DEFAULT
Open collector
---
Input
Input pulse amplitude
Noise filter
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
Low
Detecting level *1
1V (5V excitation)
2V (12V/24V excitation)
Input span frequency
Output span frequency
1000 Hz
20 Hz (output code R)
1000 Hz (all other codes)
/C02: Polyurethane coating
/C03: Rubber coating
TERMINAL SCREW MATERIAL
/S01: Stainless steel
Low-end cutout 3 Hz
Non-uniform wave averaging 1 (No averaging)
One-shot pulse width
One-shot pulse logic
400 µsec. (20ms for output signal R)
HꢀꢁOFF
*1. Internal voltage
JFR2 SPECIFICATIONS
ES-1581 Rev.10 Page 1/5
http://www.m-system.co.jp/