5秒后页面跳转
iW636-07 PDF预览

iW636-07

更新时间: 2024-11-15 00:55:15
品牌 Logo 应用领域
DIALOG 光电二极管
页数 文件大小 规格书
7页 393K
描述
AC/DC Secondary-Side Controller for Qualcomm

iW636-07 技术参数

是否Rohs认证: 符合生命周期:Contact Manufacturer
包装说明:SOT-23, 6 PINReach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.39.00.01
风险等级:5.71模拟集成电路 - 其他类型:BATTERY CHARGE CONTROLLER
最大输入电压:16 V最小输入电压:3 V
JESD-30 代码:R-PDSO-G6长度:2.9 mm
湿度敏感等级:1功能数量:1
端子数量:6最大输出电流:0.6 A
封装主体材料:PLASTIC/EPOXY封装代码:LSSOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, LOW PROFILE, SHRINK PITCH
峰值回流温度(摄氏度):NOT SPECIFIED座面最大高度:1.45 mm
表面贴装:YES端子形式:GULL WING
端子节距:0.95 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:1.6 mm
Base Number Matches:1

iW636-07 数据手册

 浏览型号iW636-07的Datasheet PDF文件第2页浏览型号iW636-07的Datasheet PDF文件第3页浏览型号iW636-07的Datasheet PDF文件第4页浏览型号iW636-07的Datasheet PDF文件第5页浏览型号iW636-07的Datasheet PDF文件第6页浏览型号iW636-07的Datasheet PDF文件第7页 
iW636  
AC/DC Secondary-Side Controller for Qualcomm® Quick ChargeTM 3.0  
USB Interface  
1 Description  
The iW636 is an AC/DC secondary-side controller for USB interface supporting Qualcomm Quick Charge 3.0 (QC3.0)  
technology and secondary-to-primary communication protocol, to enable rapid charging of QC3.0/QC2.0-enabled  
mobile devices (MDs). The iW636 resides on the secondary side of an AC/DC power supply and allows the adapter  
to be configured for multi-level output voltages from 3.6V to 12V in 200mV increments, depending on the voltage  
requested by the MD. It can be used in Dialog’s primary-side controlled AC/ DC systems to achieve fast voltage  
transition, low no-load power consumption, and fast dynamic load response.  
The iW636 implements Dialog’s proprietary secondary-to-primary digital communication technique. When paired with  
Dialog’s primary-side iW1782 controller, the iW636 eliminates the discrete decoders on the primary side, simplifying  
system designs. It uses one opto-coupler to transmit all the necessary information for rapid charging, including output  
voltage requests, output current limits, output voltage undershoot, output over-voltage, and fault and reset signals. It  
also has a built-in opto-coupler LED driver to minimize the bill of material cost.  
The iW636 and iW1782 provide double-layer cable protection. On the secondary side, the iW636 incorporates Dialog’s  
proprietary D+/D- over-voltage protection to address VBUS D+/D- soft shorts. On the primary side, the iW1782 uses  
Dialog’s SmartDefenderTM advanced hiccup technology to reduce the average output power during soft shorts  
without latch.  
Dialog’s innovative, proprietary technology ensures that power supplies designed with the iW636 and iW1782  
can provide multi-level output voltage configuration, with user-selected various output current limit combinations.  
Additionally, the chipset can achieve <10mW no-load power consumption at 5V, 2A output setting and fast dynamic  
load response in typical AC/DC rapid charge adapter designs.  
2 Features  
Supports Qualcomm® Quick ChargeTM 3.0 technology  
High Voltage Dedicated Charging Port (HVDCP) to  
provide VBUS from 3.6V to 12V in 200mV increments  
● Adaptive OVP/UV detection for most VBUS levels  
Backward compatible with QC2.0 and USB Battery  
Charging Specification Revision 1.2 (USB BC1.2)  
Double-layer cable protection:  
● Pin-to-pin compatible with iW626  
x
x
Secondary side (iW636): Proprietary D+/D- over-  
voltage protection (OVP) addresses VBUS D+/D-  
soft shorts  
● Programmable active fast discharge from a high  
voltage VBUS level to 5V at MD unplug or upon  
request with built-in switch or external switch  
Primary side (iW1782): SmartDefendersmart  
hiccup technology reduces average output power  
at fault conditions without latch  
Normally OFF state with <150µA cut-off current  
during 5V steady-state operation to achieve <10mW  
overall system no-load power consumption  
● Proprietary secondary-to-primary digital  
communication eliminates discrete decoders in the  
primary side and simplifies system designs  
● Wide operating voltage range from 3V to 16V  
Built-in opto-coupler LED driver with minimum driving  
current of 2mA  
Single opto-coupler transmits all information for  
rapid charge: output voltage requests, output current  
limits, output voltage undershoot (UV), over-voltage  
protection (OVP), and fault and reset signals  
6-lead SOT-23 package  
3 Applications  
Rapid-charging AC/DC adapters for smart phones,  
tablets, and other portable devices  
Qualcomm® Quick ChargeTM 3.0 is a product of Qualcomm Technologies, Inc.  
25-May-2016  
Product Summary  
Rev. 1.2  
www.dialog-semiconductor.com  
1 of 7  
© 2016 Dialog Semiconductor  

与iW636-07相关器件

型号 品牌 获取价格 描述 数据表
iW636-08 DIALOG

获取价格

AC/DC Secondary-Side Controller for Qualcomm
iW636-21 DIALOG

获取价格

AC/DC Secondary-Side Controller for Qualcomm
iW662 RENESAS

获取价格

Integrated Secondary-Side Synchronous Rectifier Controller and RapidCharge? Interface IC f
iW671 RENESAS

获取价格

Digital Synchronous Rectifier Replaces Schottky Diode for Higher Efficiency, Ultra-Compact
iW673 RENESAS

获取价格

Digital Green-Mode Synchronous Rectifier Controller
iW676 RENESAS

获取价格

Digital Synchronous Rectifier Replaces Schottky Diode for Ultra-High Power Density AC/DC P
IW7023 DIALOG

获取价格

16-Channel LED Driver for LCD Panel Backlighting
IW7023-00-QFN4 DIALOG

获取价格

16-Channel LED Driver for LCD Panel Backlighting
iW7027 RENESAS

获取价格

16-Channel, External Current Sinks LED Driver with Patented 2-pin Sensing to Protect Again
IW7032 DIALOG

获取价格

32-Channel LED Driver for LCD Panel Backlighting