Wide V 1A Synchronous Buck Regulator
IN
ISL85410
The ISL85410 is a 1A Synchronous buck regulator with an
input range of 3V to 36V. It provides an easy to use, high
efficiency low BOM count solution for a variety of applications.
Features
• Wide input voltage range 3V to 36V
• Synchronous Operation for high efficiency
• No compensation required
The ISL85410 integrates both high-side and low-side NMOS
FET's and features a PFM mode for improved efficiency at light
loads. This feature can be disabled if forced PWM mode is
desired. The part switches at a default frequency of 500kHz
but may also be programmed using an external resistor from
300kHz to 2MHz. The ISL85410 has the ability to utilize
internal or external compensation. By integrating both NMOS
devices and providing internal configuration options, minimal
external components are required, reducing BOM count and
complexity of design.
• Integrated High-side and Low-side NMOS devices
• Selectable PFM or forced PWM mode at light loads
• Internal fixed (500kHz) or adjustable Switching frequency
300kHz to 2MHz
• Continuous output current up to 1A
• Internal or external Soft-start
• Minimal external components required
• Power-good and enable functions available.
With the wide V range and reduced BOM the part provides an
IN
easy to implement design solution for a variety of applications
while giving superior performance. It will provide a very robust
design for high voltage Industrial applications as well as an
efficient solution for battery powered applications.
Applications
• Industrial control
• Medical devices
• Portable instrumentation
• Distributed Power supplies
• Cloud Infrastructure
The part is available in a small Pb free 4mmx3mm DFN plastic
package with an operation temperature range of -40°C to
+125°C
Related Literature
• See AN1905, “ISL85410EVAL1Z, ISL85410AEVAL1Z,
ISL85418EVAL1Z Wide VIN 1A, 800mA Synchronous Buck
Regulator”
• See AN1908, “ISL85410DEMO1Z, ISL85418DEMO1Z Wide
VIN 1A, 800mA Synchronous Buck Regulator”
100
V
= 5V
IN
95
90
85
80
75
70
65
60
55
50
V
= 12V
IN
12
11
1
2
SS
FS
V
= 15V
IN
COMP
SYNC
BOOT
VIN
R2
R3
CFB
10
9
3
4
FB
CBOOT
100nF
GND
VCC
CVIN
10µF
CVCC
1µF
V
= 24V
V
= 33V
IN
IN
5
6
VOUT
PHASE
PGND
PG
EN
L1
22µH
COUT
10µF
INTERNAL DEFAULT PARAMETER SELECTION
0
0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0
OUTPUT LOAD (A)
FIGURE 1. TYPICAL APPLICATION
FIGURE 2. EFFICIENCY vs LOAD, PFM, V
= 3.3V
OUT
November 22, 2013
FN8375.2
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 |Copyright Intersil Americas LLC 2013. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1