HC-5524
Data Sheet
February 1999
File Number 2798.6
EIA/ITU 24V PABX SLIC with 25mA
Loop Feed
Features
• DI Monolithic High Voltage Process
The HC-5524 telephone Subscriber Line Interface Circuit
integrates most of the BORSCHT functions on a monolithic
IC. The device is manufactured in a Dielectric Isolation (DI)
process and is designed for use as a 24V interface between
the traditional telephone subscriber pair (Tip and Ring) and
the low voltage filtering and coding/decoding functions of the
line card. Together with a secondary protection diode bridge,
the device will withstand 500V induced surges, in plastic
packages. The SLIC also maintains specified transmission
performance in the presence of externally induced
longitudinal currents. The BORSCHT functions that the SLIC
provides are:
• Compatible with Worldwide PBX and DLC Performance
Requirements
• Controlled Supply of Battery Feed Current with
Programmable Current Limit
• Operates with 5V Positive Supply (V +)
B
• Internal Ring Relay Driver and a Utility Relay Driver
• High Impedance Mode for Subscriber Loop
• High Temperature Alarm Output
• Low Power Consumption During Standby Functions
• Switch Hook, Ground Key, and Ring Trip Detection
• Selective Power Denial to Subscriber
• Battery Feed with Subscriber Loop Current Limiting
• Overvoltage Protection
• Ring Relay Driver
• Voice Path Active During Power Denial
• Supervisory Signaling Functions
• Hybrid Functions (with External Op-Amp)
• Test (or Battery Reversal) Relay Driver
• On-Chip Op Amp for 2-Wire Impedance Matching
Applications
• Solid State Line Interface Circuit for PBX or Digital Loop
Carrier Systems
In addition, the SLIC provides selective denial of power to
subscriber loops, a programmable subscriber loop current
limit from 20mA to 60mA, a thermal shutdown with an alarm
output and line fault protection. Switch hook detection, ring
trip detection and ground key detection functions are also
incorporated in the SLIC device.
• Hotel/Motel Switching Systems
• Direct Inward Dialing (DID) Trunks
• Voice Messaging PBXs
The HC-5524 SLIC is ideally suited for line card designs in
PBX and DLC systems, replacing traditional transformer
solutions.
• 2-Wire/4-Wire, 4-Wire/2-Wire Hybrid
• Related Literature
- AN9607, Impedance Matching Design Equations
- AN9628, AC Voltage Gain
Ordering Information
- AN9608, Implementing Pulse Metering
TEMP.
PKG.
NO.
o
- AN549, The HC-5502S/4X Telephone Subscriber Line
Interface Circuits (SLIC)
PART NUMBER RANGE ( C)
PACKAGE
44 Ld PLCC
28 Ld SOIC
HC4P5524-9
HC9P5524-5
-40 to 85
0 to 75
N44.65
M28.3
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
1