GENLINX™
GS9001
EDHCoprocessor
DATA SHEET
FEATURES
DESCRIPTION
Error Detection and Handling (EDH) according to
SMPTE RP165
The GS9001 implements error detection and handling (EDH)
functions according to SMPTE RP165. Interfacing to the
parallel port of either the GS9002/GS9022 serial digital
encoders or GS9000 decoder, the GS9001 provides EDH
insertion and extraction for 4ƒsc NTSC, 4ƒsc PAL and 4:2:2
component standards up to 18 MHz luminance sampling.
The GS9001 also generates timing signals such as horizontal
sync,verticalblanking,fieldIDandancillarydataidentification.
The ancillary data identification aids the extraction of ancillary
data from the data stream.
EDH insertion and extraction in one device
autostandard operation
I2C Serial communications interface for access to
error flags and device configuration
available stand alone mode
error flags available on dedicated outputs
ThedevicehasanI2C(Inter-IntegratedCircuit)serialinterface
bus for communication with a microcontroller. The device
can be programmed as an I2C slave transmitter or receiver by
the microcontroller. This interface can be used to read the
complete set of error flags and override the flag status prior to
re-transmission. The device automatically determines the
operating standard which can be overridden through the I2C
interface. Timingsignalsandtransmissionerrorflagsarealso
available on dedicated outputs.
field, vertical, horizontal timing signals, ancillary data
indication and TRS indication
video standard and invalid data indication
reserved words readable and writeable
21 bit Errored Fields counter
passthrough mode to bypass EDH packet insertion
true 8-bit compatibility
40 MHz operating frequency
Pb-free and Green
ORDERINGINFORMATION
Part Number
Package
Temperature
Pb-Free and Green
GS9001-CQM 44 PQFP
GS9001-CQME3 44 PQFP
o°C to 70°C
No
APPLICATIONS
• 4ƒsc, 4:2:2 and 360 Mb/s serial digital interfaces
• Source and destination equipment
• Distribution equipment
o°C to 70°C
Yes
Device Address
• Test equipment
2
I
C
Interface
Serial Clock
& Data
Transmission
Error Flags
Ancillary
Check
Error Flags
&
Format
CRC
Extraction
Interrupt
Compare
Transmit/
Receive
Errored
Field
Counter
Automatic
Standards
Detection
Mux
Data
Out
Control
Logic
Field Signals/
Standard Indication
Data In
Clock
Reset
CRC
Calculation
HSync, VBlank,
Ancillary Data, TRS-ID,
TRS Absence Indication
I2C is a registered Trademark of Philips
Revision Date: June 2004
BLOCK DIAGRAM
Document No. 521 - 38 - 04
GENNUM CORPORATION P.O. Box 489, Stn A, Burlington, Ontario, Canada L7R 3Y3 tel. (905 632-2996 fax: (905) 632-5946
Gennum Japan: Shinjuku Green Tower Building 27F 6-14-1, Nishi Shinjuku Shinjuku-ku, Tokyo 160-0023 Japan
Tel: +81 (03) 3349-5501 Fax: +81 (03) 3349-5505