5秒后页面跳转
GPM55-5G PDF预览

GPM55-5G

更新时间: 2024-11-21 13:07:59
品牌 Logo 应用领域
SLPOWER 电源电路输出元件
页数 文件大小 规格书
2页 91K
描述
AC-DC Regulated Power Supply Module, 55W

GPM55-5G 技术参数

生命周期:Obsolete包装说明:,
Reach Compliance Code:unknown风险等级:5.84
Is Samacsys:N模拟集成电路 - 其他类型:AC-DC REGULATED POWER SUPPLY MODULE
认证:CE, TUV, UL效率(主输出):70%
高度:42.67 mm最大输入电压:264 V
最小输入电压:85 V长度:160.02 mm
最高工作温度:50 °C最低工作温度:
最大输出电流:11 A标称输出电压:5 V
保护:OUTPUT OVER CURRENT; OUTPUT OVER VOLTAGE纹波电压(主输出):0.01768 Vrms
子类别:Power Supply Modules最大总功率输出:55 W
宽度:100.08 mmBase Number Matches:1

GPM55-5G 数据手册

 浏览型号GPM55-5G的Datasheet PDF文件第2页 
GPM55 SERIES  
INSTALLATION INSTRUCTIONS  
SL POWER ELECTRONICS CORP.  
6050 King Drive, Bdlg A  
Ventura, CA 93003 + 805-486-4565  
Internet: www.slpower.com  
RATINGS Input: 100-240 VAC, 1.7 A, 50/60 Hz  
Outputs: 55 Watts Maximum Continuous Power - Total of all Outputs.  
Model  
Output #1  
I
Output #2  
I
Output #3  
I
Output #4  
I
sc  
sc  
sc  
sc  
GPM55A  
GPM55B  
GPM55C  
GPM55D  
GPM55E  
GPM55F  
+5VDC 6A  
+5VDC 6A  
+5VDC 6A  
+5VDC 6A  
+5VDC 6A  
+5VDC 6A  
5VDC 11A  
12VDC 4.7A  
15VDC 3.7A  
24VDC 2.3A  
28VDC 2.0A  
4A +12VDC 3A  
4A +12VDC 3A  
4A +15VDC 3A  
4A +12VDC 1A  
4A -5VDC 1A  
4A -5VDC 1A  
3A  
3A  
3A  
3A  
3A  
3A  
-12VDC 1A  
-12VDC 1A  
-15VDC 1A  
-12VDC 1A  
-15VDC 1A  
-15VDC 1A  
3A  
3A  
3A  
3A  
3A  
3A  
4A +24VDC 1.5A 2A +12VDC 1A  
4A +24VDC 1.5A 2A +15VDC 1A  
4A +12VDC 3A  
2A +15VDC 1A  
Notes:  
1.  
GPM55-5  
GPM55-12  
GPM55-15  
GPM55-24  
GPM55-28  
5A  
2A  
2A  
1A  
1A  
I
= Maximum output short circuit current.  
sc  
2. Maximum ambient temperature for continuous output power of 55W is 50°C.  
3. Maximum Relative Humidity 96%, no condensation.  
SAFETY DECLARATION: SL Power Electronics Corp. (SLPE) declares under our sole responsibility  
that all models listed above are in conformity with the applicable requirements of EN60950-1 following the  
provisions of the Low Voltage Directive 2006/95/EC. All models are Certified to be in compliance with the  
applicable requirements of CSA 22.2 No. 234 (Level 3) (with additional tests to C22.2 No 601.1-M90 per  
T.I.L. CA-08), EN/IEC/UL 60601-1.  
CLASSIFICATION:  
(5.1) Protection against electric shock = Class I  
(5.2) Degree of protection against electric shock = Signal output or intermediate  
(In accordance with sub-  
clause 5 of IEC 60601-1) (5.3) Protection against harmful ingress of water = Ordinary (no protection)  
(5.5) Have not been evaluated for use in the presence of a flammable anaesthetic mixture with  
air, oxygen, or nitrous oxide. This evaluation is made on the end equipment by the OEM.  
(5.6) Mode of operation = Continuous  
CAUTION: When performing Dielectric Strength Tests, catastrophic failure of the unit may result if a Dielectric Strength  
test voltage greater than 1800 Vac is applied between primary and secondary circuits. The components providing isolation  
from primary to secondary cannot be tested while installed in the power supply without overstressing basic (primary to  
ground) insulation. All isolating components are individually 100% tested at 4800 Vac prior to installation.  
ISOLATION: The creepage distance between primary and ground is 4 mm minimum; between primary and secondary  
circuits is 8 mm minimum. Secondary to ground creepage is not defined or controlled. The output common is bypassed to  
ground using a 0.01µF 1KV capacitor. The required creepage and clearance distances from primary circuits to ground and  
secondary circuits must be maintained after installation to preserve the intended safety.  
GROUNDING: The Protective Earth (ground) terminal J1, pin 1 and all of the pads around the mounting holes must be  
bonded to Protective Earth in the host equipment. Metallic spacers should be used to mount supply to metal surfaces. When  
mounting to non-metallic surfaces, connect all mounting pads together and bond to earth. Using the Protective Earth terminal  
on the supply for grounding the host equipment is not recommended. A separate dedicated grounding point should be used.  
OUTPUTS: All output commons should be connected to Protective Earth in the end application. The output(s) are intended  
for Protectively Earthed Signal Output and Intermediate Circuits only. The output(s) are not acceptable for patient connection  
without additional isolation. All DC outputs are SELV under normal and single fault conditions.  
41-32494-0001 REV. L  

与GPM55-5G相关器件

型号 品牌 获取价格 描述 数据表
GPM55A SLPOWER

获取价格

55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55AG SLPOWER

获取价格

AC-DC Regulated Power Supply Module, 55W
GPM55B SLPOWER

获取价格

55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55BG SLPOWER

获取价格

GLOBAL PERFORMANCE SWITCHERS
GPM55C SLPOWER

获取价格

55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55CG SLPOWER

获取价格

AC-DC Regulated Power Supply Module, 55W
GPM55D SLPOWER

获取价格

55 Watt Global Performance Switchers
GPM55DG SLPOWER

获取价格

AC-DC Regulated Power Supply Module, 55W
GPM55E SLPOWER

获取价格

55 Watt Global Performance Switchers
GPM55EG SLPOWER

获取价格

AC-DC Regulated Power Supply Module, 55W