GPM55-24

更新时间： 2024-11-21 12:25:27

品牌	Logo	应用领域
SLPOWER		电源电路输出元件
页数	文件大小	规格书
2页	91K
描述
55 Watts Maximum Continuous Power - Total of all Outputs.

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

GPM55-24 技术参数

生命周期：	Obsolete	包装说明：	,
Reach Compliance Code：	unknown	风险等级：	5.73
Is Samacsys：	N	模拟集成电路 - 其他类型：	AC-DC REGULATED POWER SUPPLY MODULE
认证：	CE, TUV, UL	效率（主输出）：	70%
高度：	42.67 mm	最大输入电压：	264 V
最小输入电压：	85 V	长度：	160.02 mm
最高工作温度：	50 °C	最低工作温度：
最大输出电流：	2.3 A	标称输出电压：	24 V
保护：	OUTPUT OVER CURRENT; OUTPUT OVER VOLTAGE	纹波电压（主输出）：	0.08484 Vrms
子类别：	Power Supply Modules	最大总功率输出：	55 W
宽度：	100.08 mm	Base Number Matches：	1

GPM55-24 数据手册

GPM55 SERIES

INSTALLATION INSTRUCTIONS

SL POWER ELECTRONICS CORP.

6050 King Drive, Bdlg A

Ventura, CA 93003 + 805-486-4565

Internet: www.slpower.com

RATINGS Input: 100-240 VAC, 1.7 A, 50/60 Hz

Outputs: 55 Watts Maximum Continuous Power - Total of all Outputs.

Model

Output #1

Output #2

Output #3

Output #4

GPM55A

GPM55B

GPM55C

GPM55D

GPM55E

GPM55F

+5VDC 6A

5VDC 11A

12VDC 4.7A

15VDC 3.7A

24VDC 2.3A

28VDC 2.0A

4A +12VDC 3A

4A +15VDC 3A

4A +12VDC 1A

4A -5VDC 1A

-12VDC 1A

-15VDC 1A

-12VDC 1A

-15VDC 1A

4A +24VDC 1.5A 2A +12VDC 1A

4A +24VDC 1.5A 2A +15VDC 1A

4A +12VDC 3A

2A +15VDC 1A

Notes:

GPM55-5

GPM55-12

GPM55-15

GPM55-24

GPM55-28

= Maximum output short circuit current.

2. Maximum ambient temperature for continuous output power of 55W is 50°C.

3. Maximum Relative Humidity 96%, no condensation.

SAFETY DECLARATION: SL Power Electronics Corp. (SLPE) declares under our sole responsibility

that all models listed above are in conformity with the applicable requirements of EN60950-1 following the

provisions of the Low Voltage Directive 2006/95/EC. All models are Certified to be in compliance with the

applicable requirements of CSA 22.2 No. 234 (Level 3) (with additional tests to C22.2 No 601.1-M90 per

T.I.L. CA-08), EN/IEC/UL 60601-1.

CLASSIFICATION:

(5.1) Protection against electric shock = Class I

(5.2) Degree of protection against electric shock = Signal output or intermediate

(In accordance with sub-

clause 5 of IEC 60601-1) (5.3) Protection against harmful ingress of water = Ordinary (no protection)

(5.5) Have not been evaluated for use in the presence of a flammable anaesthetic mixture with

air, oxygen, or nitrous oxide. This evaluation is made on the end equipment by the OEM.

(5.6) Mode of operation = Continuous

CAUTION: When performing Dielectric Strength Tests, catastrophic failure of the unit may result if a Dielectric Strength

test voltage greater than 1800 Vac is applied between primary and secondary circuits. The components providing isolation

from primary to secondary cannot be tested while installed in the power supply without overstressing basic (primary to

ground) insulation. All isolating components are individually 100% tested at 4800 Vac prior to installation.

ISOLATION: The creepage distance between primary and ground is 4 mm minimum; between primary and secondary

circuits is 8 mm minimum. Secondary to ground creepage is not defined or controlled. The output common is bypassed to

ground using a 0.01µF 1KV capacitor. The required creepage and clearance distances from primary circuits to ground and

secondary circuits must be maintained after installation to preserve the intended safety.

GROUNDING: The Protective Earth (ground) terminal J1, pin 1 and all of the pads around the mounting holes must be

bonded to Protective Earth in the host equipment. Metallic spacers should be used to mount supply to metal surfaces. When

mounting to non-metallic surfaces, connect all mounting pads together and bond to earth. Using the Protective Earth terminal

on the supply for grounding the host equipment is not recommended. A separate dedicated grounding point should be used.

OUTPUTS: All output commons should be connected to Protective Earth in the end application. The output(s) are intended

for Protectively Earthed Signal Output and Intermediate Circuits only. The output(s) are not acceptable for patient connection

without additional isolation. All DC outputs are SELV under normal and single fault conditions.

41-32494-0001 REV. L

中文翻译

下载PDF

与GPM55-24相关器件

型号	品牌	获取价格	描述	数据表
GPM55-24G	SLPOWER	获取价格	AC-DC Regulated Power Supply Module, 55W
GPM55-28	SLPOWER	获取价格	55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55-28G	SLPOWER	获取价格	AC-DC Regulated Power Supply Module, 55W
GPM552R	ETC	获取价格	Analog IC
GPM55-5	SLPOWER	获取价格	55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55-5G	SLPOWER	获取价格	AC-DC Regulated Power Supply Module, 55W
GPM55A	SLPOWER	获取价格	55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55AG	SLPOWER	获取价格	AC-DC Regulated Power Supply Module, 55W
GPM55B	SLPOWER	获取价格	55 Watts Maximum Continuous Power - Total of all Outputs.
GPM55BG	SLPOWER	获取价格	GLOBAL PERFORMANCE SWITCHERS

与GPM55-24相关文章

解析光耦仿真器：升级光耦合器技术的必要性
2024-11-18

31
英伟达新一代Blackwell GPU过热问题致交付延迟
2024-11-18

22
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
2024-11-14

51
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
2024-11-14

50

产品中心

服务支持

精选活动

关于我们

帮助中心

GPM55-24

GPM55-24 技术参数

GPM55-24 数据手册

与GPM55-24相关器件

与GPM55-24相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

GPM55-24

GPM55-24 技术参数

GPM55-24 数据手册

与GPM55-24相关器件

与GPM55-24相关文章

您还可以找

您在本页遇到什么问题？