FNA25012A
1200 V Motion SPM)
2ꢀSeries
General Description
The FNA25012A is a Motion SPM 2 module providing
®
a fully−featured, high−performance inverter output stage for AC
induction, BLDC, and PMSM motors. These modules integrate
optimized gate drive of the built−in IGBTs to minimize EMI and
losses, while also providing multiple on−module protection features:
under−voltage lockouts, over−current shutdown, temperature sensing,
and fault reporting. The built−in, high−speed HVIC requires only
a single supply voltage and translates the incoming logic−level gate
inputs to high−voltage, high−current drive signals to properly drive the
module’s internal IGBTs. Separate negative IGBT terminals are
available for each phase to support the widest variety of control
algorithms.
www.onsemi.com
Features
• 1200 V − 50 A 3−Phase IGBT Inverter, Including Control Ics for
Gate Drive and Protections
• Low−Loss, Short−Circuit−Rated IGBTs
• Very Low Thermal Resistance Using AIN DBC Substrate
• Built−In Bootstrap Diodes and Dedicated Vs Pins Simplify PCB
Layout
SPMCA−A34/34 LD, PDD STD, DBC DIP TYPE
CASE MODFQ
• Separate Open−Emitter Pins from Low−Side IGBTs for Three−Phase
Current Sensing
Figure 1. 3D Package Drawing
• Single−Grounded Power Supply Supported
• Built−In NTC Thermistor for Temperature Monitoring and
Management
(Click to Activate 3D Content)
MARKING DIAGRAM
• Adjustable Over−Current Protection via Integrated Sense−IGBTs
• Isolation Rating of 2500 Vrms/1 min.
Applications
FNA25012A
XXX YWW
• Motion Control − Industrial Motor (AC 400 V Class)
Related Resources
®
• AN9075 − Users Guide for 1200 V SPM 2 Series
®
• AN9076 − Mounting Guide for New SPM 2 Package
®
• AN9079 − Thermal Performance of 1200 V Motion SPM 2 Series
FNA25012A
XXX
= Specific Device Code
= Lot Code
by Mounting Torque
YWW
= Work Week Code
ORDERING INFORMATION
See detailed ordering and shipping information on page 2 of
this data sheet.
© Semiconductor Components Industries, LLC, 2018
1
Publication Order Number:
October, 2018 − Rev. 3
FNA25012A/D