DPD Demodulator for PA
IDTF1350
Datasheet
Linearization, 1300MHz to 2900MHz
DESCRIPTION
FEATURES (I OR Q PATH)
This document describes the specification for the
IDTF1350 Digital Pre-Distortion Demodulator for PA
linearization. This series of devices is offered in 2
variants to cover common UTRA bands. See part
number matrix below for additional detail.
•
•
•
•
•
•
•
•
•
•
•
•
Wide flat performance IF BW
Wide RF and LO BWs (~ 1.6 GHz)
Ideal for Multi-Carrier Systems
Drives ADC directly
Ultra linear +41 dBm IP3O
Low Noise Figure
Excellent ACLR performance
200 Ω output impedance
Fully integrated DPD demodulator
6x6 36 pin package
Standby Mode w/Fast Recovery
ICC: 275 mA
COMPETITIVE ADVANTAGE
In typical base station transmitters digital pre-distortion
is employed to improve the Transmitter performance.
The signal coming out of the PA is sampled and the
incoming Tx chain I&Q data is pre-distorted to
counteract the distortion inherent in the PA. The PA
signal is adjusted via a digital step attenuator to a lower
level and then sub-sampled at an IF frequency of ~200
MHz which necessitates the need for a highly linear
demodulator to downmix to quadrature IF from the
Transmit frequency. By sampling IF_I and IF_Q
independently and then digitally combining these signals,
an effective doubling of the sample rate can be achieved.
Any distortion in this path will degrade the performance
of the DPD algorithm. By utilizing an ultra-linear
demodulator w/integrated DSA such as the IDTF1350,
the ACLR and/or power consumption of the full Tx
system can be improved
BLOCK DIAGRAM
CSb SDI CLK
SPI
DEC
IFI
SPLIT
STBY
ISET
Bias
Control
2
90O
.
IBIAS
significantly.
RFIN_Y
RFIN_X
IFQ
DPD full path ACLR: ⇓ 1 dB
Icc: DPD function Power
Consumption ⇓ 40%
LOIN
RF VCO
Zero-DistortionTM Demod eliminates 2 IF
amps
Integrates 2 BPFs, 2 Baluns,
SPDT RF switch
ORDERING INFORMATION
Glitch-FreeTM gain control
Omit IDT
0.8 mm height
package
TM
Tape &
Reel
Glitch-FreeTM
prefix
PART# MATRIX
IDTF1350NBGI8
Part#
F1300
F1350
RF range
550 - 1150
1300 - 2900
UTRA
bands
IF freq
range
Typ.
Gain
Injection
RF product Line
Green Industrial
5,6,8,12,13,
14,17
High Side
or Low Side
20 - 350
12.5
Temp range
1,2,3,4,9,10
7,21, 24, 38
High Side
or Low Side
20 - 500
12.5
IDT Zero-DistortionTM, Glitch-FreeTM DPD Receiver
1
January 21, 2020