5秒后页面跳转
EL6259 PDF预览

EL6259

更新时间: 2024-11-19 22:49:11
品牌 Logo 应用领域
ELANTEC 振荡器驱动器二极管激光二极管
页数 文件大小 规格书
2页 45K
描述
Low Noise 4-Channel Laser Diode Driver + Oscillator

EL6259 数据手册

 浏览型号EL6259的Datasheet PDF文件第2页 
EL6259C - Product Brief  
Low Noise 4-Channel Laser Diode Driver + Oscillator  
Features  
General Description  
Low output noise = 4.0nA/rt-Hz  
High-performance laser diode  
driver  
The EL6259C is a low noise four channel laser diode current amplifier  
that provides controlled current to a grounded laser diode. The four  
amplifiers can provide up to 150 mA per channel of DC or pulsed cur-  
rent. Channels 2, 3, and 4 must be used as the write channels, with  
switching speeds of approximately one nanosecond rise/fall time. All  
four channels are summed together at the IOUT output, allowing the  
user to create multilevel waveforms in order to optimize laser diode  
performance. The level of the output current is set by an analog volt-  
age applied to an external resistor which converts the voltage into a  
current at the IIN pin. The current seen at this pin is then amplified by  
Pin compatible with EL6257  
Voltage-controlled output current  
source to 150 mA per channel,  
requiring one external set resistor  
per channel  
Current-controlled output current  
source to 150 mA per channel  
Rise time = 1.0 ns  
Fall time = 1.1 ns  
On chip oscillator with frequency  
and amplitude control by use of  
external resistors to ground  
Oscillator to 500 MHz  
Oscillator to 100 mA pk/pk  
Single +5V supply (±10%)  
100X to become a current source at pin IOUT.  
An on-chip 500 MHz oscillator is provided to allow current modula-  
tion when in the read mode. This is turned on when the EOSC pin is  
held high (floating not recommended). Complete control of amplitude  
and frequency is set by two external resistors connected to ground at  
pins RFREQ and RAMP (see graphs in this data sheet for further  
explanation).  
Output current pulses are enabled when an Lsignal is applied to the  
OE pin. No output current flows when OE is H, and additional laser  
diode protection is provided since the OE input will float high when  
open. Complete IOUT shut-off is also achieved by holding the CE pin  
low, which will override the OE control pins.  
Disable feature for power-up  
protection and power savings  
TTL/CMOS control signals  
Applications  
The external resistors allow the user to accurately and independently  
set each amplifier transconductance by applying a voltage to each  
resistor, without restriction on the voltage range, thus ensuring broad  
voltage DAC compatibility. Alternatively, the IIN pin can be biased  
from a current DAC or other current source.  
DVD-RAM high speed drives  
CD-RW applications  
Writable optical drives  
Laser diode current switching  
Ordering Information  
Part No  
Temp. Range  
Package  
Outline #  
Connection Diagram  
EL6259CU  
0°C to +70°C  
QSOP-24  
MDP0040  
1
2
24  
23  
22  
21  
20  
19  
18  
17  
16  
15  
14  
13  
GND  
GND  
I
V
CC  
INR  
3
GND  
V
I
CC  
4
I
IN2  
OUT  
OUT  
5
RFREQ  
I
6
I
I
GND  
RAMP  
CE  
IN3  
IN4  
7
8
OER  
OE2  
OE3  
OE4  
GND  
9
EOSC  
10  
11  
12  
V
CC  
V
CC  
Complete Product Specifications  
Elantec Technical Support:  
GND  
North America: 1-888-352-6832 X 311  
Asia: +85-45-682-5820  
Europe: +44-18-977-6020  
©2000 Elantec Semiconductor, Inc.  

与EL6259相关器件

型号 品牌 获取价格 描述 数据表
EL6259C ELANTEC

获取价格

Low Noise 4-Channel Laser Diode Driver + Oscillator
EL6259CU ELANTEC

获取价格

Laser Driver with Ocillator and APC
EL6261C ELANTEC

获取价格

Quad 20MHz Quad, 80MHz, Switched Gain Pre-Amp
EL6261CU ELANTEC

获取价格

Quad 20MHz Quad, 80MHz, Switched Gain Pre-Amp
EL6262C ELANTEC

获取价格

Quad 20MHz & Quad, 70MHz, Switched Gain Pre-Amp
EL6262CU ELANTEC

获取价格

Quad 20MHz & Quad, 70MHz, Switched Gain Pre-Amp
EL6263C ELANTEC

获取价格

Quad 20MHz & Quad 70MHz, Switched Gain Pre-Amp
EL6263CU ELANTEC

获取价格

Quad 20MHz & Quad 70MHz, Switched Gain Pre-Amp
EL6265C ELANTEC

获取价格

13 Channel, 60MHz, Switched Gain Pre-Amp
EL6270C ELANTEC

获取价格

Laser Driver with Ocillator and APC