EL2082
®
Data Sheet
J a nua ry 1996, Re v.D
FN7152
Current Mode Multiplier
Features
The EL2082 is a general purpose
variable gain control building block,
built using an advanced proprietary
• Flexible inputs and outputs, all ground referred
• 150MHz large and small-signal bandwidth
• 46dB of calibrated gain control range
complementary bipolar process. It is a two-quandrant
multiplier, so that zero or negative control voltages do not
allow signal feedthrough and very high attenuation is
possible. The EL2082 works in current mode rather than
voltage mode, so that the input impedance is low and the
output impedance is high. This allows very wide bandwidth
for both large and small signals.
• 70dB isolation in disable mode @ 10MHz
• 0.15% diff gain and 0.05° diff phase performance at NTSC
using application circuit
• Operates on ±5V to ±15V power supplies
• Outputs may be paralleled to function as a multiplexer
The I pin replicates the voltage present on the V pin;
IN IN
therefore, the V pin can be used to reject common-mode
Applications
IN
noise and establish an input ground reference. The gain
control input is calibrated to 1mA/mA signal gain for 1V of
control voltage. The disable pin (E) is TTL-compatible, and
the output current can comply with a wide range of output
voltages.
• Level adjust for video signals
• Video faders and mixers
• Signal routing multiplexers
• Variable active filters
Because current signals rather than voltages are employed,
multiple inputs can be summed and many outputs wire-or'ed
or mixed.
• Video monitor contrast control
• AGC
The EL2082 operates from a wide range of supplies and is
available in standard 8-pin plastic DIP or 8-pin SO.
• Receiver IF gain control
• Modulation/demodulation
• General “cold” front-panel control of AC signals
EL2082
(8-PIN SO, PDIP)
TOP VIEW
Ordering Information
PART
NUMBER
EL2082CN
EL2082CS
TEMP. RANGE PACKAGE
PKG. NO.
MDP0031
MDP0027
0°C to +75°C
0°C to +75°C
8-Pin PDIP
8-Pin SO
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.
All other trademarks mentioned are the property of their respective owners.