EL1883
®
Data Sheet
July 26, 2004
FN7010.1
Sync Separator with Horizontal Output
Features
The EL1883 video sync separator is
manufactured using Elantec’s high
• NTSC, PAL, SECAM, non-standard video sync separation
• Fixed 70mV slicing of video input levels from 0.5V to
2V
P-P
P-P
performance analog CMOS process.
This device extracts sync timing information from both
standard and non-standard video input and also in the
presence of Macrovision pulses. It provides composite sync,
vertical sync, burst/back porch timing, and horizontal
outputs. Fixed 70mV sync tip slicing provides sync edge
• Low supply current - 1.5mA typ.
• Single 3V to 5V supply
• Composite sync output
• Vertical output
detection when the video input level is between 0.5V
and
P-P
(sync tip amplitude 143mV to 572mV). A single
2V
P-P
• Horizontal output
external resistor sets all internal timing to adjust for various
video standards. The composite sync output follows video in
sync pulses and a vertical sync pulse is output on the rising
edge of the first vertical serration following the vertical pre-
equalizing string. For non-standard vertical inputs, a default
vertical pulse is output when the vertical signal stays low for
longer than the vertical sync default delay time. The
horizontal output gives horizontal timing with pre/post
equalizing pulses.
• Burst/back porch output
• Macrovision compatible
• Available in 8-pin SO package
• Pb-free available
Applications
• Video amplifiers
• PCMCIA applications
• A/D drivers
The EL1883 is available in an 8-pin SO package and is
specified for operation over the full -40°C to +85°C
temperature range.
• Line drivers
Ordering Information
• Portable computers
• High speed communications
• RGB applications
• Broadcast equipment
• Active filtering
PART
NUMBER
PACKAGE
8-Pin SO
8-Pin SO
8-Pin SO
TAPE & REEL PKG. DWG. #
EL1883IS
-
7”
13”
-
MDP0027
MDP0027
MDP0027
MDP0027
EL1883IS-T7
EL1883IS-T13
EL1883ISZ
(See Note)
8-Pin SO
(Pb-free)
Demo Board
• A dedicated demo board is available
EL1883ISZ-T7
(See Note)
8-Pin SO
(Pb-free)
7”
MDP0027
MDP0027
Pinout
EL1883ISZ-
T13 (See Note)
8-Pin SO
(Pb-free)
13”
EL1883
(8-PIN SO)
TOP VIEW
NOTE: Intersil Pb-free products employ special Pb-free material
sets; molding compounds/die attach materials and 100% matte tin
plate termination finish, which is compatible with both SnPb and
Pb-free soldering operations. Intersil Pb-free products are MSL
classified at Pb-free peak reflow temperatures that meet or exceed
the Pb-free requirements of IPC/JEDEC J Std-020B.
VDD
COMPOSITE SYNC OUT
COMPOSITE VIDEO IN
VERTICAL SYNC OUT
GND
1
2
3
4
8
7
6
5
HORIZONTAL OUTPUT
RSET
BURST/BACK
PORCH OUTPUT
CCAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003, 2004. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.
All other trademarks mentioned are the property of their respective owners.