LARGE CAPACITANCE ALUMINUM ELECTROLYTIC CAPACITORS
KMQ
Downsized snap-ins, 105
C
@Downsized from current downsized snap-ins KMH series
@Endurance with ripple current : 105C 2000 hours
@Non solvent-proof type
@Pb-free design
downsized
KMH
SPECIFICATIONS
?
Items
Characteristics
Category
Temperature Range
-25 to +105C
Rated Voltage Range 160 to 450Vdc
Capacitance Tolerance P20% (M)
(at 20C, 120Hz)
(at 20C after 5 minutes)
(at 20C, 120Hz)
Leakage Current
I[3 CV
Where, I : Max. leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (V)
Dissipation Factor
(tane)
Rated voltage (Vdc)
tanE (Max.)
160 to 250V 315 to 400V 420 & 450V
0.15 0.15 0.20
160 to 250V 315 to 400V 420 & 450V
Low Temperature
Characteristics
(Max. Impedance Ratio)
Rated voltage (Vdc)
Z(-25C)/Z(+20C)
4
8
8
(at 120Hz)
Endurance
Shelf Life
The following specifications shall be satisfied when the capacitors are restored to 20C after subjected to DC voltage with the rated
ripple current is applied for 2000 hours at 105C.
Capacitance change
D.F. (tanE)
[P20% of the initial value
[200% of the initial specified value
[The initial specified value
Leakage current
The following specifications shall be satisfied when the capacitors are restored to 20C after exposing them for 1000 hours at 105C
without voltage applied.
Capacitance change
D.F. (tanE)
[P15% of the initial value
[150% of the initial specified value
[The initial specified value
Leakage current
DIMENSIONS [mm]
?
@Terminal Code
@Terminal Code
: VS (F22 to F35) : Standard
: LI (F35)
Sleeve (PET)
PC board pin-out
Sleeve (PET)
PC board pin-out
-1.2B6
Negative mark
Negative mark
2
5P0.5
2-F2
14.2P1
4.0P0.5
LP2
LP2
4.5P1
Vent
Vent
No plastic disk is the standard design.
PART NUMBERING SYSTEM
?
1
2
3
4
5
6
7
8
9
10
11 12 13
14
15 16 17
18
E KMQ A A A V S N A A A M A A A S
Supplement code
Size code
Capacitance tolerance code
Capacitance code (ex. 68MF:680,3300MF:332)
Dummy terminal code
Terminal code (VS, LI)
Voltage code (ex. 160V:161,315V:3B1,450V:451)
Series code
Category
Please refer to "A guide to global code (snap-in type)"
(1/3)
CAT. No. E1001E