5秒后页面跳转
ECEC2DC221CB PDF预览

ECEC2DC221CB

更新时间: 2024-11-06 06:55:39
品牌 Logo 应用领域
松下 - PANASONIC /
页数 文件大小 规格书
4页 63K
描述
Snap-in Type

ECEC2DC221CB 数据手册

 浏览型号ECEC2DC221CB的Datasheet PDF文件第2页浏览型号ECEC2DC221CB的Datasheet PDF文件第3页浏览型号ECEC2DC221CB的Datasheet PDF文件第4页 
Aluminum Electrolytic Capacitors/MC  
Snap-in Type  
Country of Origin  
Series:  
Type :  
TS  
MC  
Japan  
n Features  
Endurance: 105°C 2000 h  
U.S.A  
Malaysia  
n Recommended Applications  
Smoothing circuits, AC adaptor  
n Specifications  
-40 to + 105°C  
200 to 250 V .DC  
120 to 1500 µ F  
-25 to + 105°C  
400 to 450 V .DC  
Category temp. range  
Rated W.V. Range  
39 to 390 µ F  
Nominal Cap. Range  
Capacitance Tolerance  
±20 % (120Hz/+20°C)  
0.03 CV (µA) or 3 mA, whichever is smaller, after 5 minutes application of rated working  
voltage at +20°C. C:Capacitance(µF) V: W.V. (V.DC)  
Please see the attached standard products list.  
DC Leakage Current  
tan δ  
Frequency (Hz)  
Correction Factor  
50  
0.75  
60  
0.80  
100  
0.95  
120  
1.00  
500  
1.20  
1k  
1.25  
10k to  
1.40  
Frequency Correction  
Factor for Ripple Current  
After 2000 hours application of DC voltage with specified ripple current (< rated DC working  
voltage) at +105°C, the capacitor shall meet the following limits.  
Endurance  
Capacitance change ±20 % of initial measured value  
< 200 % of initial specified value  
< initial specified value  
tan δ  
DC leakage current  
After storage for 1000 hours at +105±2 °C with no voltage applied and then being stabilized  
at +20 °C, capacitors shall meet the limits specified in Endurance.(With voltage treatment)  
Shelf Life  
Please contact the factory for detailed information on test methods and standards  
relating overvoltage characteristics.  
Overvoltage  
n Dimensions in mm (not to scale)  
(10.0) 2-φ2.0±0.1  
10.0±0.1  
Polarity bar  
P.V.C. sleeve  
Vent  
L+2.0 max  
Recommended PWB piercing plan  
i
(Standard terminal type)  
Terminal  
(t=0.8)  
+0.2  
0.8-0.1  
+0.2  
2.0max  
2.0max  
0.8-0.1  
i
i
Bottom of can  
Bottom of can  
1.5 ± 0.2  
1.5±0.2  
Standard terminal type does not require  
terminal trimming process.  
Design, and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase  
and / or use. Should a safety concern arise regarding this product,please be sure to contact us immediately.  
Mar. 2005  
EE166 —