DATASHEET
Ambient Light Sensor – Surface Mount
EAALSTIC2012A0
Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within once
in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of
each terminal. Be careful because the damage of the product is often started at the time of the hand solder.
Repairing
Repair should not be done after the device have been soldered. When repairing is unavoidable, a double-head
soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the
device will or will not be damaged by repairing.
Note:
1. Above specification may be changed without notice. Everlight Americas will reserve authority on material change for above
specification.
2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification
sheets. Everlight Americas assumes no responsibility for any damage resulting from use of the product which does not comply with
the absolute maximum ratings and the instructions included in these specification sheets.
3. These specification sheets include materials protected under copyright of Everlight Americas Inc. Please don’t reproduce or cause
anyone to reproduce them without Everlight Americas’s consent.
9
Copyright © 2010, Everlight Americas Inc. All Rights Reserved. Release Date : 11.21.2011. Issue No: 1
www.everlightamericas.com