Differential Pressure Gauge with Alarms
DS2818
Features:
•
•
•
Magnehelic® design
Retains low DP sensiꢁvity and accuracy
Adjustable high and low set points
Description:
Based on the Magnehelic® design, this gauge retains the low DP sensiꢁvity and accuracy whilst adding two relay outputs for
high and low DP alarms. The Photohelic® principle uses the standard gauge pointer to interrupt infra-red beams at the
adjustable set points, which then drive the output relays. High and low set points are adjustable using the front mounted
knobs.
Specification / Features
DP Ranges
Accuracy
Pascals
±2% FSD
Media
Air & non-corrosive gases
Die-cast Aluminum
1/8” NPT Female (rear and side)
25 psig
Housing
Process Connecꢁons
Max Pressure
Temperature
Output
-5°C to 50°C
2x SPDT relays, 1 Amp @ 30Vdc,
0.5 Amp at 125Vac
Electrical Connecꢁon
Panel Cut out
Overall Size
460mm 8 core able
123mm dia
140m dia x 65mm deep
0.75kg
Weight
General Note
TT Electronics | Roxspur Measurement & Control
2 Downgate Drive, Sheffield, South Yorkshire, S4 8BT, UK |Ph: +44 (0) 114-244-2521
TT Electronics reserves the right to make changes in product specificaꢁon without
noꢁce or liability. All informaꢁon is subject to TT Electronics’ own data and is
considered accurate at ꢁme of going to print.
www.ꢀelectronics.com | RoxspurSales@ꢀelectronics.com
Issue A 06/2017 Page 1
© TT electronics plc