DRV3201-Q1
www.ti.com
SLVSBD6 –MAY 2012
3 Phase Motor Driver-IC for Automotive Safety Applications
Check for Samples: DRV3201-Q1
1
FEATURES
APPLICATIONS
2
•
•
•
•
Qualified for Automotive Applications
•
Automotive Safety Critical Motor-Control
Applications
AEC-Q100 Qualified
–
–
–
–
Electrical Power Steering (EPS, EHPS)
3 Phase Bridge Driver for Motor Control
Electrical Brake/Brake Assist
Transmission
Drives 6 Separate N-Channel Power MOSFETs
up to 250 nC Gate Charge
•
Programmable 140 mA–1 A Gate Current Drive
(Source/Sink) for Easy Output Slope
Adjustment
Oil-Pump
•
Industrial Safety Critical Motor-Control
Applications
•
•
–7 V to 40 V Compliance on All FET Driver
Pins to Handle Inductive Under/Overshooting
DESCRIPTION
The bridge driver is dedicated to automotive 3 phase
brushless DC motor control including safety relevant
applications. It provides six dedicated drivers for
normal level N-Channel MOSFET transistors. The
driver capability is designed to handle gate charges
of 250 nC, and the driver source/sink currents are
programmable for easy output slope adjustment. The
device also incorporates sophisticated diagnosis,
protection and monitoring features through an SPI
interface. A boost converter with integrated FET
provides the overdrive voltage, allowing full control on
the power-stages even for low battery voltage down
to 4.75 V.
Separate Control Input for Each Power
MOSFET
•
•
•
•
PWM Frequency up to 30 kHz
Supports 100% Duty Cycle Operation
Operating Voltage: 4.75 to 30 V
Proper Low Supply Voltage Operation Due to
Integrated Boost Converter for Gate-Driver
Voltage Generation
•
•
Logic Functional Down to 3 V
Short Circuit Protection With VDS-Monitoring
and Adjustable Detection Level
Battery Voltage
•
Two Integrated High Accuracy Current Sense
Amplifiers With Two Gain-Programmable
Second Stage for Higher Resolution at Low
Load Current Operation
Boost Converter
B_EN
Controller
3 × Phase Comp
GNDLS_B
PHxC
•
•
Over and Undervoltage Protection
ERR
Control Logic
and
Safety / Diagnostic
3 Phase Gate Driver
SPI
Shoot Through Protection With Programmable
Dead Time
RSTN
EN
3 × PowerStage
GHSx
SHSx
IHSx, ILSx
DRVOFF
BLDC
Motor
•
•
•
Three Real Time Phase Comparators
GLSx
SLSx
VCC5
VCC3
Internal
Supply
Over Temperature Warning and Shut Down
x = 1..3
ADREF
Shift Buffer
RI
Sophisticated Failure Detection and Handling
Through SPI Interface
RO
2 × 2nd Current Sense Amp
2 × 1st Current Sense Amp
IPy
INy
O3,4
2 × Current Shunt
•
Reverse Battery Protection Down to –4 V (With
Series Protection Resistance)
y = 1..2
•
•
•
Sleep Mode Function
Figure 1. Typical Application Diagram
Reset and Enable Function
Package: 64-pin HTQFP PowerPAD™
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
PowerPAD is a trademark of Texas Instruments.
PRODUCT PREVIEW information concerns products in the
formative or design phase of development. Characteristic data and
other specifications are design goals. Texas Instruments reserves
the right to change or discontinue these products without notice.
Copyright © 2012, Texas Instruments Incorporated