12/00
0.01 TO 4.0 GHz
ANALOG DETECTOR
DAC4101
Typical Values @ +25° C
DAC4101
DAC4101
Wide Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.01 to 4.5 GHz
Wide Power Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . . –30.0 to 5.0 dBm
Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Single Power Supply
± 0.25 dB
± 0.3 dB
1.5:1
TO-8 Package for Detectors
0.450 (11.43)
DIA.
Standard Size TO-8
0.025
(0.64)
0.208 (5.28)
MAX.
0.185 ± 0.015
(4.70 ± 0.38)
SPECIFICATIONS
0.018 ± 0.002
(0.46 ± 0.05)
(4) PLCS
DIA. PIN
Guaranteed*
0.504 (12.80)
DIA.
Parameter
Typical
0 to 50° C
-55 to +85° C
GROUND
Frequency (Min.)
0.01-4.5 GHz
0.01-4.0 GHz
0.01-4.0 GHz
50 OHM INPUT
50 OHM OUTPUT
Input Power Range (Min.)
VSWR (Max.)
-30 to 5 dBm
1.5:1†
-25 to 0 dBm
1.8:1†
-25 to 0 dBm
1.8:1†
0.033 (0.84)
0.031 (0.79)
Sensitivity, Vout (Min.)
Power Flatness (Max.)
Temperature Stability (Max.)
120 mV†
±0.3 dB^
±0.25 dB^
90 mV†
90 mV†
±0.6 dB^
±0.5 dB^
±0.6 dB^
±0.5 dB^
45° ± 3°
+DC VOLTAGE
0.300
(7.62)
DIA. B.C.
Output Offset Voltage,
no RF (Max.)
+0.5 mV
-10 dBm
+2.0 mV
+2.0 mV
1 dB Square Law Departure
Tangential Sensitivity
—
—
—
—
—
—
—
—
DIMENSIONS ARE IN INCHES (MILLIMETERS)
-45 dBm^^
1.5 µsec‡
Pulse Response, Pin = -15 dBm
Pulse Response, Pin = 5 dBm
Max Output Voltage
4.0 µsec‡
Vs-1 Volts
2 +mA, 2 -mA
9 +mA, 2 -mA
Supply Current, no RF
—
—
DAS4101
Supply Current, Pin = 5 dBm
SMTO-8 Package for Detectors
* 50-ohm source impedance, 2 KΩ||50 pF output load, +5 Vdc. † Pin = –15 dBm.
^ Vout = 100 mV. ^^ 3 dB NF, 1 MHz Bandwidth. ‡ 50% RF to 10 or 90% Video.
DETAIL A
(NO SCALE)
0.016 ± 0.002
0.010 ± 0.002
DC BIAS
MAXIMUM RATINGS
0
DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Continuous RF Input Power . . . . . . . . . . . . . . . . . . . .
+18 V
+14.0 dBm
0.016 ± 0.002
(0.41 ± 0.05)
(4) PLCS
50 Ω INPUT
0.008
0.012
0.250
(6.35)
Operating Case Temperature . . . . . . . . . . . . . . . . . . . -55° C to +100° C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . -65° C to +125° C
50 Ω OUTPUT
0.450
(11.43)
Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . .
Detector Thermal Resistance1 (θjc) . . . . . . . . . . . . . . .
Temperature Rise @ 0 dBm (Tjc) . . . . . . . . . . . . . . . .
Temperature Rise @ 5 dBm (Tjc) . . . . . . . . . . . . . . . .
+100° C
3500° C/Watt
3.5° C
0.040 ± 0.012
(1.02 ± 0.30)
(4) PLCS
GND
SEE
DETAIL "A"
0.170
(4.32)
0.050
(1.27)
35° C
(4) PLCS
1 Thermal resistance is based on total power dissipation. Ratings based on +25° C.
0
0.100
(2.54)
(4) PLCS
0.075
(1.91)
0.200
(5.08)
0.350
(8.89)
0.450
APPLICATIONS
0.031
(0.79)
0.031
(0.79)
This unit is DC coupled and employs a RF choke at the input (DC short). If the application
calls for the input to sink current there will be approximately an additional 1 mV of output
offset voltage for each 3 mA of current. Sink current should be limited to 100 mA max to
avoid choke burnout.
(11.43)
0.010
(0.25)
0.008 ± 0.001
(0.20 ± 0.03)
(TYP.)
45°
For higher supply voltages, up to ±15 volts, the positive supply pin must include a series
current limiting resistor, Rs = (Vs – 5) / 0.01 (e.g., Vs = +15v, Rs = 1.0KΩ).
Average power detection is obtained at power levels below approximately
–13 dBm.
For best pulse response the supply pins should be bypassed with an additional
1.0 µF capacitor. The unit contains 0.01 µF internal capacitors.
390
408-522-3838 • Fax 408-522-3839 • www.cougarcorp.com
2001