DA9131
High-Performance, Dual-Channel DC-DC
Converter for Mobile and Portable Applications
General Description
DA9131 is an power management IC (PMIC) suitable for supplying CPUs, GPUs, DDR memory rails
in single in-line pin package (SIPP) modules, mobile, portable and consumer applications.
DA9131 integrates two single-phase buck converters, each phase requiring a small external 0.22 µH
inductor. Each buck is capable of delivering up to 5 A output current at a 0.3 V to 1.9 V output
voltage range. The 2.8 V to 5.5 V input voltage range is suitable for a wide variety of low-voltage
systems.
With remote sensing, the DA9131 guarantees the highest accuracy and supports multiple PCB
routing scenarios without loss of performance.
The pass devices are fully integrated, so no external FETs or Schottky diodes are needed.
A programmable soft start-up can be enabled, which limits the inrush current from the input node and
secures a slope-controlled rail activation.
The dynamic voltage control (DVC) supports adaptive adjustment of the supply voltage dependent on
the processor load, via either a direct register write using the communication interface (I2C-
compatible) or with a programmable input pin.
A configurable GPI allows multiple I2C address selection for multiple instances of DA9131 in the
same application.
DA9131 has integrated over-temperature and over-current protection for increased system reliability,
without the need for external sensing components.
Key Features
■
■
■
■
■
■
■
■
■
■
2.8 V to 5.5 V input voltage
0.3 V to 1.9 V output voltage
Up to 5 A output current per channel
4 MHz nominal switching frequency
Dual-channel
■
■
■
Programmable soft startup
I2C-compatible interface (FM+)
Voltage, current, and temperature
supervision
■
24-pin FCQFN package, wettable flanks
(nom. 3.3 mm x 4.8 mm)
220 nH inductor per channel
20 µF output capacitor
■
■
218 mm² total solution area
-40 °C to +105 ºC ambient temperature
range
±1 % output voltage accuracy (static)
±5 % load transient (dynamic)
Programmable GPIOs
■
AEC-Q100 Grade 2 qualified version also
available for Automotive applications
(DA9131-A)
Benefits
■
■
■
High Efficiency buck converters deliver outstanding thermal performance
Fully integrated switching FET’s means no external FETs or Schottky diodes are required
Remote sensing guarantees the highest accuracy and supports multiple PCB routing scenarios
without loss of performance.
■
■
Fully programmable soft-start limits the inrush current from the input to give a slope-controlled
output voltage.
Dynamic voltage control (DVC) enables adaptive adjustment of the device output voltage
depending on the load. This increases efficiency when the downstream circuitry enters low power
or idle mode, resulting in power savings.
■
Configurable GPIOs support a range of features including I2C, DVC and Power-Good indicator.
Datasheet
Revision 2.1
25-May-2022
CFR0011-120-00
1 of 57
© 2022 Renesas Electronics