CYUSB330x, CYUSB332x, CYUSB230x
HX3 Automotive SuperSpeed USB (USB 3.1
Gen 1) Hub
General description
HX3 Automotive is a family of SuperSpeed USB hub controllers compliant with the USB 3.1, Gen 1 specification.
HX3 supports SuperSpeed (SS), Hi-Speed (HS), Full-Speed (FS), and Low-Speed (LS) on all the ports. It has
integrated termination, pull-up, and pull-down resistors, and supports configuration options through pin-straps
to reduce the overall BOM of the system.
HX3 Automotive includes the following Infineon-proprietary features:
• Shared Link™: Enables extra downstream (DS) ports for on-board connections in embedded applications.
• Ghost Charge™: Enables charging of devices connected to the DS ports when no host is connected on the
upstream (US) port.
Features
• Automotive Electronics Council (AEC) Q100 qualified
• USB 3.1, Gen 1-Certified Hub, TID# 330000060
• Supports up to four USB 3.1, Gen1-Compliant DS ports
- All ports support SS (5 Gbps) and are backward-compatible with HS (480 Mbps), FS (12 Mbps), and LS
(1.5 Mbps)
- SS and USB 2.0 Link Power Management (LPM)
- Dedicated Hi-Speed Transaction Translators (Multi-TT)
- LED status indicators – suspend, SS, and USB 2.0 operation
• Shared Link for embedded applications
- Each DS port can simultaneously connect to an embedded SS device and a removable USB 2.0 device
- Enables up to six device connections
• Enhanced Battery Charging
- Each DS port complies with the USB Battery Charging v1.2 (BC v1.2) specification
- Ghost Charge: Each DS port can emulate a Dedicated Charging Port (DCP) when the host is not connected to
the US port
- Accessory Charger Adapter Dock (ACA-Dock): Enables charging and simultaneous data transfer for a smart
phone or a tablet acting as a host compliant to BC v1.2
- Apple charging supported on all DS ports
• Integrated Arm® Cortex™-M0 CPU
- 16-KB RAM, 32-KB ROM
- Configure GPIOs for overcurrent protection, power enable, and LEDs
- Upgrade firmware using I2C EEPROM or an external I2C master
• Vendor-Command support to implement a USB-to-I2C Bridge
- Firmware upgrade of an external ASSP connected to HX3 through USB
- In-System Programming (ISP) of the EEPROM connected to HX3 through USB
Datasheet
www.infineon.com
Please read the Important Notice and Warnings at the end of this document
page 1
002-11899 Rev. *D
2023-07-20