CY7C271
CY7C274
Selection Guide
7C271-35
7C274-35
7C271-45
7C274-45
7C274-30
30
7C271-55
55
Unit
ns
Maximum Access Time
35
120
130
30
45
120
130
30
Maximum Operating Com’l
120
120
mA
mA
mA
mA
Current
Military
130
Standby Current
Com’l
30
30
Military
40
40
40
Maximum Ratings[1]
DC Program Voltage .................................................... 13.0V
Static Discharge Voltage............................................ >2001V
(per MIL-STD-883, Method 3015)
(Above which the useful life may be impaired. For user guide-
lines, not tested.)
Latch-Up Current..................................................... >200 mA
UV Exposure ................................................ 7258 Wsec/cm2
Storage Temperature ..................................... −65°C to +150°C
Ambient Temperature with
Power Applied..................................................−55°C to +125°C
Operating Range
Supply Voltage to Ground Potential .................−0.5V to +7.0V
Ambient
DC Voltage Applied to Outputs
in High Z State .....................................................−0.5V to +7.0V
Range
Commercial
Military[2]
Temperature
VCC
0°C to +70°C
5V ±10%
5V ±10%
DC Input Voltage .................................................−3.0V to +7.0V
Electrical Characteristics Over the Operating Range[3]
−55°C to +125°C
7C271- 35, 45, 55
7C274-30, 35, 45,
Parameter
VOH
Description
Output HIGH Voltage
Output LOW Voltage
Input HIGH Level
Test Conditions
Min.
Max.
Unit
V
VCC = Min., IOH = −2.0 mA
VCC = Min., IOL = 8.0 mA[4]
2.4
VOL
0.4
V
VIH
GuaranteedInputLogicalHIGH Voltagefor All
Inputs
2.0
VCC
V
VIL
Input LOW Level
Guaranteed Input Logical LOW Voltage for All
Inputs
0.8
V
IIX
Input Current
GND < VIN < VCC
−10
−40
−20
+10
+40
−90
120
130
30
µA
µA
IOZ
IOS
ICC
Output Leakage Current
Output Short Circuit Current[5] VCC = Max., VOUT = GND
GND < VOUT < VCC, Output Disabled
mA
mA
Power Supply Current
VCC = Max., VIN = 2.0V,
IOUT = 0 mA, CE=VIL
Commercial
Military
ISB
Standby Supply Current
VCC = Max., CE = VIH,
IOUT = 0 mA
Commercial
Military
mA
40
VPP
IPP
Programming Supply Voltage
Programming Supply Current
12
13
V
mA
V
50
VIHP
Input HIGH Programming
Voltage
3.0
VILP
Input LOW Programming
Voltage
0.4
V
Notes:
1. The voltage on any input or I/O pin cannot exceed the power pin during power-up.
2. TA is the “instant on” case temperature.
3. See the last page of this specification for Group A subgroup testing information.
4. 6.0 mA military
5. For test purposes, not more than one output at a time should be shorted. Short circuit test duration should not exceed 30 seconds.
Document #: 38-04008 Rev. *B
Page 2 of 11