CY7C1327G
4-Mbit (256K x 18) Pipelined Sync SRAM
Features
Functional Description[1]
• Registered inputs and outputs for pipelined operation
• 256K ×18 common I/O architecture
The CY7C1327G SRAM integrates 256K x 18 SRAM cells with
advanced synchronous peripheral circuitry and a two-bit
counter for internal burst operation. All synchronous inputs are
gated by registers controlled by a positive-edge-triggered
Clock Input (CLK). The synchronous inputs include all
addresses, all data inputs, address-pipelining Chip Enable
(CE1), depth-expansion Chip Enables (CE2 and CE3), Burst
Control inputs (ADSC, ADSP, and ADV), Write Enables
(BW[A:B], and BWE), and Global Write (GW). Asynchronous
inputs include the Output Enable (OE) and the ZZ pin.
• 3.3V core power supply (VDD
)
• 2.5V I/O power supply (VDDQ
• Fast clock-to-output times
)
— 2.6 ns (for 250-MHz device)
• Provide high-performance 3-1-1-1 access rate
• User-selectable burst counter supporting Intel®
Addresses and chip enables are registered at rising edge of
clock when either Address Strobe Processor (ADSP) or
Address Strobe Controller (ADSC) are active. Subsequent
burst addresses can be internally generated as controlled by
the Advance pin (ADV).
Pentium® interleaved or linear burst sequences
• Separate processor and controller address strobes
• Synchronous self-timed writes
• Asynchronous output enable
Address, data inputs, and write controls are registered on-chip
to initiate a self-timed Write cycle.This part supports Byte Write
operations (see Pin Descriptions and Truth Table for further
details). Write cycles can be one to two bytes wide as
controlled by the byte write control inputs. GW when active
• Offered in lead-free 100-pin TQFP package, lead-free
and non-lead-free 119-ball BGA package
• “ZZ” Sleep Mode Option
causes all bytes to be written.
LOW
The CY7C1327G operates from a +3.3V core power supply
while all outputs also operate with a +3.3V or a +2.5V supply.
All inputs and outputs are JEDEC-standard JESD8-5-
compatible.
Logic Block Diagram
ADDRESS
A0, A1, A
REGISTER
A[1:0]
2
MODE
Q1
ADV
CLK
BURST
COUNTER AND
LOGIC
CLR
Q0
ADSC
ADSP
DQB,DQP
B
DQB,DQP
WRITE REGISTER
B
WRITE DRIVER
OUTPUT
BUFFERS
BW
B
A
DQs
DQP
DQP
OUTPUT
REGISTERS
SENSE
AMPS
MEMORY
ARRAY
A
B
DQA,DQP
A
E
DQA,DQP
WRITE REGISTER
A
WRITE DRIVER
BW
BWE
GW
INPUT
REGISTERS
ENABLE
REGISTER
CE1
CE2
PIPELINED
ENABLE
CE3
OE
ZZ
SLEEP
CONTROL
Note:
1. For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Cypress Semiconductor Corporation
Document #: 38-05519 Rev. *F
•
198 Champion Court
•
San Jose, CA 95134-1709
•
408-943-2600
Revised July 5, 2006