September 1999
COP87L88FH
8-Bit CMOS OTP Microcontrollers with 16k Memory,
Comparators, USART and Hardware Multiply/Divide
Family features include an 8-bit memory mapped architec-
General Description
=
=
ture, 10 MHz CKI (-XE
crystal oscillator; -TE
external
The COP87L88FH OTP (One Time Programmable) micro-
clock) with 1µs instruction cycle, hardware multiply/divide
functions, three multi-function 16-bit timer/counters with
™
controllers are highly integrated COP8 Feature core de-
vices with 16k memory and advanced features including
Analog comparators, and Hardware Multiply/Divide. These
multi-chip CMOS devices are suited for applications requir-
ing a full featured controller with comparators, a full-duplex
USART, and hardware multiply/divide functions, and as
pre-production devices for a masked ROM design. Lower
cost pin and software compatible 12k ROM versions are
available (COP888FH), as well as a range of COP8 software
and hardware development tools.
™
PWM, full duplex USART, MICROWIRE/PLUS , two Analog
comparators, two power saving HALT/IDLE modes, MIWU,
idle timer, WATCHDOG and clock monitor logic, low EMI
2.7V to 5.5V operation, and 28/40/44 pin packages.
™
Devices included in this data sheet are:
Device
Memory (bytes)
16k OTP EPROM
16k OTP EPROM
RAM (bytes)
512
I/O Pins
24
Packages
28 DIP/SOIC
Temperature
-40 to +85˚C
-40 to +85˚C
COP87L84FH
COP87L88FH
512
36/40
40 DIP, 44 PLCC
Key Features
CPU/Instruction Set Features
n Hardware Multiply/Divide Functions
n Full duplex USART
n 1 µs instruction cycle time
n Fourteen multi-source vectored interrupts servicing
— External Interrupt
n Three 16-bit timers, each with two 16-bit registers
supporting:
— Idle Timer T0
— Three Timers (Each with 2 Interrupts)
— MICROWIRE/PLUS
— Multi-Input Wake Up
— Processor Independent PWM mode
— External Event counter mode
— Input Capture mode
— Software Trap
— USART (2)
n 16 kbytes on-board EPROM with security features
n 512 bytes on-board RAM
— Default VIS (default interrupt)
n Versatile and easy to use instruction set
n 8-bit Stack Pointer (SP) — stack in RAM
n Two 8-bit Register Indirect Data Memory Pointers
(B and X)
Additional Peripheral Features
n Idle Timer
n Multi-Input Wakeup (MIWU) with optional interrupts (8)
n Two analog comparators
n WATCHDOG and Clock Monitor logic
n MICROWIRE/PLUS serial I/O
Fully Static CMOS
n Two power saving modes: HALT and IDLE
n Single supply operation: 2.7V–5.5V
n Temperature ranges: −40˚C to +85˚C
I/O Features
n Software selectable I/O options ( TRI-STATE®
,
Push-Pull, Weak Pull-Up, and High Impedance)
n Schmitt trigger inputs on ports G and L
n Packages:
— 40 DIP with 36 I/O pins
— 44 PLCC with 40 I/O pins
Development Support
n Emulation device for COP888FH
n Real time emulation and full program debug offered by
MetaLink Development System
— 28 DIP/SO with 24 I/O pins
™
COP8 is a trademark of National Semiconductor Corporation.
™
MICROWIRE is a trademark of National Semiconductor Corporation.
™
MICROWIRE/PLUS is a trademark of National Semiconductor Corporation.
TRI-STATE® is a registered trademark of National Semiconductor Corporation.
™
WATCHDOG is a trademark of National Semiconductor Corporation.
™
iceMASTER is a trademark of MetaLink Corporation.
© 1999 National Semiconductor Corporation
DS101135
www.national.com