CAH SERIES
25 TO 40 WATTS
CAH SERIES - 25 TO 40 WATTS
FEATURES
• Ultra-Wide Input Voltage Range (4:1)
• LC Input Filter for Low Reflected Ripple Current
• Regulated Outputs
• Current Limiting Short Circuit Protection
• 500VDC min. I/O Isolation
• Thermal Shutdown with Auto-Recovery
• Industry Standard Pin-Out
• Ten Year Warranty
• Operating Temp -40° to +100°C Baseplate
THE CAH SERIES FROM WALL INDUSTRIES
The CAH Series of single, dual and triple output DC/DC con-
verters performs over an ultra-wide input voltage range (4:1),
providing indefinite short circuit and overvoltage protection. The
CAH Series design technology allows for up to 40 watts output
from a 3.0 x 3.0 x 0.55”, 3.6 x 3.0 x 0.55” Baseplate. These
current mode control forward converters are designed for
improved transient response and reduced stress on switching
components.
SPECIFICATIONS: CAH SERIES
GENERAL SPECIFICATIONS
INPUT SPECIFICATIONS
Efficiency.....(5VDC in 75% typical)................80% typical
Isolation Voltage (input to output)................500 VDC min
Isolation Resistance (input to output)..............500MOhm
Switching Frequency..............................250kHz (typical)
Input Voltage Range................4.5-9, 9-36, 18-75, 55-110VDC
Nominal Input................................................5, 24, 48, 74VDC
Input Filter.............................................................LC input filter
Remote On/Off Control................................Open Collector TTL
OUTPUT SPECIFICATIONS
ENVIRONMENTAL SPECIFICATIONS
Output Current...........................................................See Table
Voltage Tolerance............................. 1% primary, 2% auxiliary
Output Trim (external)................................... 10% (primary only)
Line Regulation.................................................................0.5%
Load Regulation................................... 1% singles (see note 5)
Operating Temperature(ambient)-40 to 100°C Baseplate
Storage Temperature................................-55°C+100°C
Temperature Coefficient.....................0.02% per C° max.
Humidity (non-condensing)...................20% to 95% R.H.
Ripple/Noise (20MHz BW)..........................................75mV p-p
PHYSICAL SPECIFICATIONS
Transient Response
...........<200 u sec to within 1% Vout
Shielding...................................................................Five Sided
Weight....................................................approx. 7.0 oz.
Case Material...................................Black Coated Metal
......................................................Aluminum Baseplate
All specifications apply at +25°C ambient unless otherwise noted
Due to advances in technology, specifications subject to change without notice.
1
603 778 2300
WWW.WALLINDUSTRIES.COM