Datasheet
BU91501KV-M
(2) Read Mode (KEY RD command only)
The following occurs when Key Read by KEY RD command.
If KEY RD command is recognized at the rising edge of 8th CLK, it enters Read mode after the falling edge of 8th CLK
and then key data is output through DO.
Setting CSB=”H” can exit Read mode after or during Serial Data Transfer.
Figure 8. Serial Data Output Format
Command Transfer Method
After CSB=”H”→”L”, the 1st byte shall be a command.
Please refer to “Command Table”.
When set command except Data write(DATAWR), the next byte will be (continuously) a command.
When set DATAWR command, the following bytes will be display data bytes.
Command
Command
Command
Command
(DATAWR)
Display Data
…
Once it becomes display data transfer mode, it will not be able to send command.
If you send command again, please rise CSB=”H”.
Display Data Transfer Method
This LSI has Display Data RAM (DDRAM) of 51×4=204bit.
The relationship between data input and display data, DDRAM data and address are as follows.
Command
00001010
D1
D2
D3
D4
D5
D6
D7
D8
D9
D10 D11 D12 D13
…
→ Display Data
Display data will be stored in DDRAM. The address to be written is specified by Address set (ADSET) command and the
address is automatically incremented in every 4bit data if 1/4 Duty mode or in every 3 bit if 1/3 Duty mode respectively.
www.rohm.com
TSZ02201-0P4P0D301120-1-2
8.July.2015 Rev.001
© 2015 ROHM Co., Ltd. All rights reserved.
6/30
TSZ22111・15・001