Datasheet > ATF1508BE-7CU132

ATF1508BE-7CU132

更新时间： 2022-12-16 16:35:39

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

ATF1508BE-7CU132 数据手册

3. Power Management

Unlike conventional CPLDs with sense amplifiers, the ATF1508BE is designed using low-power

full CMOS design techniques. This enables the ATF1508BE to achieve extremely low power

consumption over the full operating frequency spectrum.

The ATF1508BE also has an optional power-down mode. In this mode, current drops to below

100 µA. When the power-down option is selected, either PD1 or PD2 pins (or both) can be used

to power down the part. When enabled, the device goes into power-down when either PD1 or

PD2 is high. In the power-down mode, all internal logic signals are latched and held, as are any

enabled outputs.

All pin transitions are ignored until the PD pin is brought low. When the power-down feature is

enabled, the PD1 or PD2 pin cannot be used as a logic input or output. However, the pin’s mac-

rocell may still be used to generate buried foldback and cascade logic signals.

All power-down AC characteristic parameters are computed from external input or I/O pins.

4. Security Feature

A fuse is provided to prevent unauthorized copying of the ATF1508BE fuse patterns. Once

enabled, fuse reading or verification is inhibited. However, the 16-bit User Electronic Signature

remains accessible. To reset this feature, the entire memory array in the device must be erased.

5. Programming Methods

The ATF1508BE devices are In-System Programmable (ISP) or In-System Configurable (ISC)

devices utilizing the 4-pin JTAG protocol. This capability eliminates package handling normally

required for programming and facilitates rapid design iterations and field changes.

When using the ISP hardware or software to program the ATF1508BE devices, four I/O pins

must be reserved for the JTAG interface. However, the logic features that the macrocells have

associated with these I/O pins are still available to the design for buried logic functions.

To facilitate ISP programming by the Automated Test Equipment (ATE) vendors, Serial Vector

Format (SVF) files can be created by Atmel-provided software utilities. ATF1508BE devices can

also be programmed using standard third-party programmers. With a third-party programmer,

the JTAG ISP port can be disabled, thereby allowing four additional I/O pins to be used for logic.

The ATF1508BE device supports several configuration modes which gives designers several

unique options for programming.

The different modes of programming are:

• ISC – In-System Configuration

• OTF – On-the-Fly Reconfiguration

• DRA – Direct Reconfiguration Access

ATF1508BE

3663A–PLD–1/08

1...7 8 91011 12 13...30

下载PDF