Features
• Clock Controller
– 80C51 core with 6 clocks per instruction
– 8 MHz On-Chip Oscillator
– PLL for generating clock to supply CPU core, USB and Smart Card Interfaces
– Programmable CPU clock from 500 KHz / X1 to 48 MHz / X1
• Reset Controller
– Power On Reset (POR) feature avoiding an external reset capacitor
– Power Fail Detector (PFD)
– Watch-Dog Timer
• Power Management
C51
– Two power saving modes : Idle and Power Down
– Four Power Down Wake-up Sources : Smart Card Detection, Keyboard Interrupt, USB
Resume, External Interrupt
Microcontroller
with USB and
Smart Card
Reader
– Input Voltage Range : 3.6V - 5.5V
– Core’s Power Consumption (Without Smart Card and USB) :
•30 mA Maximum Operating Current @ 48 MHz / X1
•200 µA Maximum Power-down Current @ 5.5V
• Interrupt Controller
– up to 9 interrupt sources
– up to 4 Level Priority
• Memory Controller
Interfaces
– Internal Program memory :
•up to 32K of FLASH or CRAM or ROM for AT8XC5122
•up to 30K of ROM for AT8XC5123
– Internal Data Memory : 768 bytes including 256 bytes of data and 512 bytes of XRAM
– Optional : internal data E2PROM 512 bytes
• Two 16-bit Timer/Counters
AT83C5122
AT83EC5122
AT85C5122
AT89C5122
AT83C5123
AT83EC5123
• USB 2.0 Full Speed Interface
– 48 MHz DPLL
– On-Chip 3.3V USB voltage regulator and transceivers
– Software detach feature
– 7 endpoints programmable with In or out directions and ISO, Bulk or Interrupt Transfers :
•Endpoint 0 : 32 Bytes Bidirectionnal FIFO for Control transfers
•Endpoints 1,2,3 : 8 bytes FIFO
•Endpoints 4,5 : 64 Bytes FIFO
•Endpoint 6 : 2*64 bytes FIFO with Pin-Pong feature
• ISO 7816 UART Interface Fully Compliant with EMV, GIE-CB and WHQL Standards
– Programmable ISO clock from 1 Mhz to 4.8 Mhz
– Card insertion/removal detection with automatic deactivation sequence
– Programmable Baud Rate Generator from 372 to 11.625 clock pulses
– Synchronous/Asynchronous Protocols T=0 and T=1 with Direct or Inverse Convention
– Automatic character repetition on parity errors
– 32 Bit Waiting Time Counter
PRELIMINARY
– 16 Bit Guard Time Counter
– Internal Step Up/Down Converter with Programmable Voltage Output :
•1.8V-30mA, 3V-60mA and 5V-60mA
– Current overload protection
– 6 kV ESD (MIL/STD 833 Class 3) protection on whole Smart Card Interface
• Alternate Smart Card Interface with CLK, IO and RST
• UART Interface with Integrated Baud Rate Generator (BRG)
• Keyboard interface with up to 20x8 matrix management capability
• Master/Slave SPI Interface
• Four 8 bit Ports, one 6 bit port, one 3-bit port
– Up to Seven LED outputs with 3 level programmable current source : 2, 4 and 10 mA
– Two General Purpose I/O programmable as external interrupts
– Up to 8 input lines programmable as interrupts
– Up to 30 output lines
Rev. 4202C–SCR–04/05
1