AT88SC3216C
3.
*Absolute Maximum Ratings
*NOTICE: Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent
damage to the device. This is a stress rating
only and functional operation of the device at
these or any other condition beyond those
indicated in the operational sections of this
specification is not implied. Exposure to
absolute maximum rating conditions for
extended periods of time may affect device
reliability.
Operating Temperature.............................−40°C to +85°C
Storage Temperature ............................−65°C to + 150°C
Voltage on Any Pin
with Respect to Ground .......................− 0.7 to VCC +0.7V
Maximum Operating Voltage.......................................6.0V
DC Output Current ..................................................5.0 mA
Table 2.
DC Characteristics
Applicable over recommended operating range from VCC = +2.7 to 5.5V, TAC = -40°C to +85°C (unless otherwise noted)
Symbol
Parameter
Supply Voltage
Test Condition
Min
Typ
Max
Units
(2)
VCC
2.7
5.5
V
ICC
ICC
ICC
ICC
ISB
Supply Current (VCC = 5.5V)
Supply Current (VCC = 5.5V)
Supply Current (VCC = 5.5V)
Supply Current (VCC = 5.5V)
Standby Current (VCC = 5.5V)
SDA/IO Input Low Threshold
SCL/CLK Input Low Threshold
RST Input Low Threshold
SDA/IO Input High Threshold
SCL/CLK Input High Threshold
RST Input High Threshold
SDA/IO Input Low Current
SCL/CLK Input Low Current
RST Input Low Current
Async READ at 3.57MHz
Async WRITE at 3.57MHz
Synch READ at 1MHz
Synch WRITE at 1MHz
VIN = VCC or GND
5
mA
mA
mA
mA
mA
V
5
5
5
1
(1)
VIL
0
VCC x 0.2
VCC x 0.2
VCC x 0.2
VCC
(1)
VIL
0
V
(1)
VIL
0
V
(1)(2)
VIH
VCC x 0.7
VCC x 0.7
VCC x 0.7
V
(1)(2)
VIH
VCC
V
(1)(2)
VIH
VCC
V
IIL
0 < VIL < VCC x 0.15
0 < VIL < VCC x 0.15
0 < VIL < VCC x 0.15
VCC x 0.7 < VIH < VCC
VCC x 0.7 < VIH < VCC
VCC x 0.7 < VIH < VCC
20K ohm external pull-up
IOL = 1mA
15
μA
μA
μA
μA
μA
μA
V
IIL
15
IIL
50
IIH
SDA/IO Input High Current
SCL/CLK Input High Current
RST Input High Current
20
IIH
100
IIH
150
VOH
VOL
IOH
SDA/IO Output High Voltage
SDA/IO Output Low Voltage
SDA/IO Output High Current
VCC x 0.7
0
VCC
VCC x 0.15
20
V
VOH
μA
Notes: 1. VIL min and VIH max are reference only and are not tested.
2. To prevent Latch Up Conditions from occurring during Power Up of the AT88SCxxxxC, VCC must be turned
on before applying VIH. For Powering Down, VIH must be removed before turning VCC off.
5
5014KS–SMEM–08/09