Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0 (0,0) and 3 (1,1)
• Medium-voltage and Standard-voltage Operation
– 5.0 (VCC = 4.5V to 5.5V)
– 2.7 (VCC = 2.7V to 5.5V)
• 3.0 MHz Clock Rate (5V)
• 32-byte Page Mode
• Block Write Protection
– Protect 1/4, 1/2, or Entire Array
• Write Protect (WP) Pin and Write Disable Instructions for
both Hardware and Software Data Protection
• Self-timed Write Cycle (5 ms Typical)
• High-reliability
– Endurance: One Million Write Cycles
– Data Retention: 100 Years
• 8-pin PDIP and 8-lead JEDEC SOIC Packages
SPI Serial
Automotive
EEPROMs
8K (1024 x 8)
16K (2048 x 8)
32K (4096 x 8)
64K (8192 x 8)
Description
The AT25080/160/320/640 provides 8192/16384/32768/65536 bits of serial electri-
cally-erasable programmable read only memory (EEPROM) organized as
1024/2048/4096/8192 words of 8 bits each. The device is optimized for use in many
automotive applications where low-power and low-voltage operation are essential.
The AT25080/160/320/640 is available in space saving 8-pin PDIP and 8-lead JEDEC
SOIC packages.
The AT25080/160/320/640 is enabled through the Chip Select pin (CS) and accessed
via a 3-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and
Serial Clock (SCK). All programming cycles are completely self-timed, and no sepa-
rate ERASE cycle is required before WRITE.
AT25080
AT25160
AT25320
AT25640
BLOCK WRITE protection is enabled by programming the status register with one of
four blocks of write protection. Separate program enable and program disable instruc-
tions are provided for additional data protection. Hardware data protection is provided
via the WP pin to protect against inadvertent write attempts to the status register. The
HOLD pin may be used to suspend any serial communication without resetting the
serial sequence.
Pin Configuration
Pin Name
Function
8-pin PDIP
8-lead SOIC
CS
Chip Select
CS
SO
1
2
3
4
8
7
6
5
VCC
HOLD
SCK
SI
CS
SO
1
2
3
4
8
7
6
5
VCC
HOLD
SCK
SI
SCK
SI
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
WP
WP
GND
GND
SO
GND
VCC
WP
Power Supply
Write Protect
Suspends Serial Input
No Connect
HOLD
NC
DC
Don’t Connect
Rev. 3260A–SEEPR–02/02
1