Datasheet
AS8510
Data Acquisition Device for Battery Sensors
ꢀ
Option for multiplexing either one differential
input, or two single ended inputs or the internal temperature
sensor on one channel
1 General Description
The AS8510 is a virtually offset free, low noise, two channel
measurement device. It is tailored to accurately measure battery
current from mA range up to kA range in conjunction with a 100 µΩ
shunt resistor in series with the battery rail. Through the second
measurement channel it enables capture of, either battery voltage
synchronous with the current measurement, or, measure the analog
output of an internal or external temperature sensor. Both channels
are matched and can either measure small signals up to ±160 mV
versus ground, through programmable gain amplifier or larger
signals in the 0 to 1V range without the amplifier.
ꢀ
Programmable current source for external temperature sensor
connectable to any of the inputs
ꢀ
ꢀ
ꢀ
High precision and high stability 1.2V reference voltage source
Digital signal processing with filter options for both channels
Four operating modes providing
- Continuous data acquisition (or)
- Periodic single-shot acquisition, (or)
- Continuous acquisition on threshold crossing of programmed
current levels (or)
After analog to digital conversion and digital filtering, the resulting
16-bit digital words are accessible through 4-wire standard serial
interface.The device includes a number of additional features
explained in the next section.
- A combination of the above
ꢀ
On chip high-precision 4MHz RC oscillator or option for external
clock
ꢀ
ꢀ
ꢀ
ꢀ
-40ºC to +125ºC ambient operation
AEC - Q100 automotive qualified
Internal chip ID for full traceability
SSOP-20 pin package
2 Key Features
ꢀ
ꢀ
ꢀ
3.3V supply voltage
Two High resolution 16 bit Σ−Δ A/D converters
Programmable sampling to enable data throughputs from less
than 1Hz to 8kHz
3 Applications
The AS8510 is ideal for shunt based batteries sensor. For high-side
current sensing, the input signal may be conditioned using
ꢀ
ꢀ
ꢀ
Zero Offset for both channels
Independent control of data rate on both channels
Precision, low noise, programmable gain amplifiers for both
channels with gains 5, 25, 40, 100 to support wide dynamic
ranges.
austriamicrosystems device AS8525 before applying to this device.
Figure 1. AS8510 Block Diagram
REF
DVDD
AVDD
Internal Temperature Sensor
Bandgap Reference
Oscillators
Prog-Cur
Source
ETR
ETS
VBAT_IN
MUX and
Chopper
16-bit Sigma-Delta ADC
PGA
MEN
VBAT_GND
CHOP_CLK
FIR / MA
AS8510
INT
CLK
RSHH
RSHL
Chopper
PGA
16-bit Sigma-Delta ADC
Analog Common Mode
VCM
Serial Interface
AVSS
SCLK CS SDI
SDO DVSS
www.austriamicrosystems.com/AS8510
Revision 3.4
1 - 46