Data Sheet
AS5130
8 Bit Programmable Magnetic Rotary Encoder
with Motion Detection & Multiturn
1 General Description
2 Key Features
ꢀ
360º contactless angular position encoding
The AS5130 is a contactless magnetic rotary encoder
for accurate angular measurement over a full turn of
360º. It is a system-on-chip, combining integrated Hall
elements, analog front end and digital signal processing
in a single device. The angle can be measured using
only a simple two-pole magnet rotating over the center
of the chip. The magnet may be placed above or below
the IC. The absolute angle measurement provides
instant indication of the magnet’s angular position with a
resolution of 8 bit = 256 positions per revolution. This
digital data is available as a serial bit stream and as a
PWM signal. The AS5130 can be operated in pulsed
mode (Vsupply=off), which reduces the average power
consumption significantly. During Vsupply=off, the
measured angle can be stored using an internal storage
register supplied by a low power voltage line. This mode
achieves very low power consumption during polling of
the rotary position of the magnet. If the position of the
magnet changes, then the motion detection feature
wakes up an external system. The device is capable of
counting the amount of magnet revolutions. The multi
turn counter value is stored in a register and can be read
in addition to the angle information. Furthermore, any
arbitrary position can be set as zero-position. The
system is tolerant to misalignment, air gap variations,
temperature variations and external magnetic fields and
high reliability due to non-contact sensing.
ꢀ
Two digital 8-bit absolute outputs:
- Serial interface
- Pulse width modulated (PWM) output
User programmable zero position
ꢀ
ꢀ
ꢀ
High speed: up to 30000 rpm
Failure detection mode for magnet placement moni-
toring and loss of power supply
ꢀ
ꢀ
ꢀ
ꢀ
Wide temperature range: - 40ºC to +125ºC
Multi Turn counter / Movement detection
Small Pb-free package: SSOP-16 (5.3mm x 6.2mm)
Automotive qualified to AEC-Q100, grade 1
3 Applications
The AS5130 is an ideal solution for Ignition key position
sensing, Steering wheel position sensing, Transmission
gearbox encoder, Front panel rotary switches and
replacement of Potentiometers.
Figure 1. Block Diagram
SINP / SINN / COSP / COSN
PWM
PWM
AS5130
Decoder
Angle
tracking
ADC &
Angle
Sin
DIO
Zero
Pos.
Absolute
Serial
Interface
(SSI)
Cos
CS
Hall Array
&
Frontend
Amplifier
decoder
DCLK
Mag
AGC
C1
AGC
CAO
power management
PROG
OTP
www.austriamicrosystems.com
Revision 1.09
1 - 40