AP4SMA11A thur AP4SMA33CA
Surface Mount Transient Voltage Suppressors
Peak Pulse Power 400W Stand Off Voltage 11V thur 33V
Features
• Glass passivated junction
• Moisture sensitivity: level 1, per J-STD-020
• Low profile package with built-in strain relief for surface
mounted applications
• Optimized for LAN protection applications
• Very Fast response time
• 400 W peak pulse power capability with a 10/1000 µs waveform
• Halogen-free according to IEC 61249-2-21 definition
• High temperature soldering guaranteed: 250℃/10 seconds at terminals
• AEC-Q101 qualified
Typical Applications
Use in sensitive electronics protection against voltage transients induced by inductive load switching
and lighting on ICs, MOSFET, signal lines of sensor units for consumer, computer, industrial,
automotive and telecommunication.
Maximum Ratings (TA = 25 °C unless otherwise noted)
Value
Unit
Parameter
Symbol
Peak Pulse Power Dissipation at TA=25ºC by 10/1000μs
Waveform (Fig.1)(Note1)(Note2)
PPPM
400
W
IPPM
IFSM
See Next Table
40
A
Peak pulse current with a 10/1000us waveform(Note1)
Peak Forward Surge Current, 8.3ms Single Half Sine Wave
(Note2)
W
RΘJL
RΘJA
30
Typical Thermal Resistance Junction to Lead
Typical Thermal Resistance Junction to Ambient
℃/W
℃/W
120
TJ, TSTG
-55 to +150
Operating junction and storage temperature range
℃
Notes:
1. Mounted on copper pad area of 0.2x0.2” (5.0 x 5.0mm) to each terminal.
2. Mounted on minimum recommended pad layout
www.goodark.com
1/7
2018.07-Rev.A