AP1201
Single-Channel Power Distribution Switch
ꢀFeatures
ꢀGeneral Description
The AP1201 series are integrated high-side power
switch with enable, flag functions and adjustable
current-limit 0.7A to 1.25A, optimized for
self-powered and bus-powered Universal Serial
Bus (USB) applications. The AP1201 series support
the following USB requirements: each switch
channel supplies up to 700mA as required by USB
downstream devices; the switch’s low on-resistance
meets USB voltage drop requirements; fault current
is limited to typically 900mA~1.25A; and a flag
output is available to indicate fault conditions to the
local USB controller. Soft start eliminates the
momentary voltage drop on the upstream port that
may occur when the switch is enabled in
bus-powered applications.
- 100mΩ typical on-resistance
- 2.7V to 5.5V input voltage
- Adjustable current-limit 0.7A to 1.25A
(AP1201A/C)
- Fixed current-limit (1.25A) for AP1201B
- Fault flag with internal delay circuit
- 1μA typical off-state supply current
- 65μA typical on-state supply current
- Output can be forced higher than input (off-state)
- Thermal shutdown
- 2.4V typical under voltage lockout (UVLO)
- Slow turn-on (soft-start) and fast turn-off
- Enable Active-High or active-Low
- SOT23-5L, SOT23-6L and SOT89-5L packages
Additional features include thermal shutdown to
prevent catastrophic switch failure from high-current
loads, under voltage lockout (UVLO) to ensure that
the device remains off unless there is a valid input
voltage present, and 3.3V and 5V logic compatible
enable inputs.
ꢀApplications
-
-
-
USB Power Switch
Battery-charger circuits
Hot plug-in power supplies
ꢀ Pin Assignments
ꢀPin Descriptions
IN
IN
OUT
GND
EN
1
5
OUT
GND
1
5
Name
Descriptions
AP1201A
SOT23-5L
AP1201A
AP1201B
SOT23-5L
AP1201B
2
3
2
3
Enable: Logic-compatible Enable input.
(H: active high, L: active low). Do not
float.
Fault Flag: Active-low, open-drain
output. Indicates over current, UVLO,
and thermal shutdown.
EN
74
5
74
5
SET EN
FLG
FLG
GND
IN
OUT IN
GND GND
OUT
GND
EN
IN
1
1
Ground: Supply return.
2
3
2
3
GND
SET
Supply Input: Output MOSFET drain.
Also supplies IC’s internal circuitry.
Connect to positive supply.
74
1
74
EN
FLG
SOT89-5L
SOT89-5L
Switch Output: Output MOSFET
source. Typically connect to switched
side of load.
OUT
6
IN
OUT
SET
AP1201C
SOT23-6L
GND
EN
2
3
5
SET
FLG
Current limit set input. A resistor pull
high to set current-limit value (A, C
type only).
7
4
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of
this product. No rights under any patent accompany the sale of the product.
Rev. 0.4 Feb 10, 2004
1/9