5秒后页面跳转
ALD2704PA PDF预览

ALD2704PA

更新时间: 2024-11-25 04:32:15
品牌 Logo 应用领域
先进线性 - ALD 运算放大器光电二极管
页数 文件大小 规格书
6页 49K
描述
DUAL RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER

ALD2704PA 技术参数

是否Rohs认证: 不符合生命周期:Contact Manufacturer
零件包装代码:DIP包装说明:,
针数:8Reach Compliance Code:unknown
ECCN代码:EAR99HTS代码:8542.33.00.01
风险等级:5.25Is Samacsys:N
放大器类型:OPERATIONAL AMPLIFIER最大平均偏置电流 (IIB):0.0003 µA
标称共模抑制比:83 dB最大输入失调电压:6000 µV
JESD-30 代码:R-PDIP-T8湿度敏感等级:1
负供电电压上限:-6.6 V标称负供电电压 (Vsup):-5 V
功能数量:2端子数量:8
最高工作温度:70 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装形状:RECTANGULAR
封装形式:IN-LINE峰值回流温度(摄氏度):225
认证状态:Not Qualified标称压摆率:5 V/us
子类别:Operational Amplifier供电电压上限:6.6 V
标称供电电压 (Vsup):5 V表面贴装:NO
技术:CMOS温度等级:COMMERCIAL
端子形式:THROUGH-HOLE端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED标称均一增益带宽:2100 kHz
Base Number Matches:1

ALD2704PA 数据手册

 浏览型号ALD2704PA的Datasheet PDF文件第2页浏览型号ALD2704PA的Datasheet PDF文件第3页浏览型号ALD2704PA的Datasheet PDF文件第4页浏览型号ALD2704PA的Datasheet PDF文件第5页浏览型号ALD2704PA的Datasheet PDF文件第6页 
A
L
D
DVANCED  
INEAR  
EVICES, INC.  
ALD2704A/ALD2704B  
ALD2704  
DUAL RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER  
GENERAL DESCRIPTION  
FEATURES  
The ALD2704 is a dual monolithic operational amplifier with MOSFET  
input that has rail-to-rail input and output voltage ranges. The input  
voltage range and output voltage range are very close to the positive and  
negative power supply voltages. Typically the input voltage can be  
• Rail-to-rail input and output voltage ranges  
• Symmetrical push-pull output drives  
• Output settles to 2mV of supply rails  
• 5.0V/µs slew rate  
• Highcapacitiveloadcapability--upto4000pF  
• No frequency compensation required -- unity  
gain stable  
+
beyond positive power supply voltage V or the negative power supply  
-
voltage V by up to 300mV. The output voltage swings to within 60mV of  
either positive or negative power supply voltages at rated load.  
• Extremely low input bias currents -- <1.0pA  
typical (20pA max.)  
• Ideal for high source impedance applications  
• High voltage gain -- typically 100V/mV  
• Output short circuit protected  
With high impedance load, the output voltage of the ALD2704 ap-  
proaches within 1mV of the power supply rails. This device is designed  
as an alternative to the popular J-FET input operational amplifier in  
applicationswhereloweroperatingvoltages,suchas9Vbatteryor±3.25V  
to ±6Vpowersuppliesarebeingused. TheALD2704offershighslewrate  
of 5V/µs. It is designed and manufactured with Advanced Linear Devices'  
standardenhancedACMOSsilicongateCMOSprocess, and it offerslow  
unit cost and exceptional reliability.  
• Unity gain bandwidth of 2.1MHz  
APPLICATIONS  
• Voltage amplifier  
• Voltage follower/buffer  
• Charge integrator  
The rail-to-rail input and output feature of the ALD2704 expands signal  
voltage range for a given operating supply voltage and allows numerous  
analog serial stages to be implemented without losing operating voltage  
margin. The output stage is designed to drive up to 10mA into 400pF  
capacitive and 1.5Kresistive loads at unity gain and up to 4000pF at a  
gain of 5. Short circuit protection to either ground or the power supply rails  
is at approximately 15mA clamp current. Due to complementary output  
stage design, the output can source and sink 10mA into a load with  
symmetrical drive and is ideally suited for applications where push-pull  
voltage drive is desired.  
• Photodiode amplifier  
• Data acquisition systems  
• High performance portable instruments  
• Signal conditioning circuits  
• Low leakage amplifiers  
• Active filters  
• Sample/Hold amplifier  
• Picoammeter  
• Current to voltage converter  
• Coaxial cable driver  
• Capacitive sensor amplifier  
• Piezoelectric transducer amplifier  
For each of the operational amplifier, the offset voltage is trimmed on-chip  
to eliminate the need for external nulling in many applications. For  
precision applications, the output is designed to settle to 0.1% in 2µs. In  
large signal buffer applications, the operational amplifier can function as  
an ultrahigh input impedance voltage follower /buffer that allows input and  
output voltage swings from positive to negative supply voltages. This  
featureisintendedtogreatlysimplifysystemsdesignandeliminatehigher  
voltage power supplies in many applications.  
PIN CONFIGURATION  
ORDERING INFORMATION  
Operating Temperature Range*  
+
OUT  
1
8
V
A
A
-55°C to +125°C  
0°C to +70°C  
0°C to +70°C  
-IN  
2
3
7
6
OUT  
-IN  
B
8-Pin  
8-Pin  
8-Pin  
CERDIP  
Package  
Small Outline  
Package (SOIC)  
Plastic Dip  
Package  
+IN  
A
-
B
V
4
5
+IN  
B
ALD2704A DA  
ALD2704B DA  
ALD2704 DA  
ALD2704A SA  
ALD2704B SA  
ALD2704 SA  
ALD2704A PA  
ALD2704B PA  
ALD2704 PA  
TOP VIEW  
DA, PA, SA PACKAGE  
* Contact factory for industrial temperature range  
© 1998 Advanced Linear Devices, Inc. 415Tasman Drive, Sunnyvale, California 94089 -1706 Tel: (408) 747-1155 Fax: (408) 747-1286 http://www.aldinc.com  

与ALD2704PA相关器件

型号 品牌 获取价格 描述 数据表
ALD2704PAL ALD

获取价格

DUAL RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2704SA ALD

获取价格

DUAL RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2704SAL ALD

获取价格

DUAL RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2706 ALD

获取价格

DUAL ULTRA MICROPOWER RAIL TO RAIL CMOS OPERATIOAAL AMPLIFIER
ALD2706_10 ALD

获取价格

DUAL ULTRA MICROPOWER RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2706A ALD

获取价格

DUAL ULTRA MICROPOWER RAIL TO RAIL CMOS OPERATIOAAL AMPLIFIER
ALD2706ADA ALD

获取价格

DUAL ULTRA MICROPOWER RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2706APA ETC

获取价格

Voltage-Feedback Operational Amplifier
ALD2706APAL ALD

获取价格

DUAL ULTRA MICROPOWER RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD2706ASA ETC

获取价格

Operational Amplifier