AH3563Q
HIGH VOLTAGE HIGH SENSITIVITY
AUTOMOTIVE HALL EFFECT LATCH SWITCH
Description
Pin Assignments
The AH3563Q is an AECQ100-qualified high-voltage, high-sensitivity
Hall effect omnipolar switch IC designed for position and proximity
sensing in automotive applications, such as in seat and seatbelt
buckle, steering lock/immobilization, gear stick, transmission actuator
and gear position, HVAC compression, wiper, door/trunk closure, and
so on. To support a wide range of demanding applications, the design
is optimized to operate over the supply range of 3.0V to 28V. With
chopper-stabilized architecture and an internal bandgap regulator to
provide temperature compensated supply for internal circuits, the
AH3563Q provides a reliable solution over the whole operating range.
For robustness and protection, the device has a reverse blocking
diode with a zener clamp on the supply. The output has an
overcurrent limit and a zener clamp.
(Top View)
3 OUTPUT
1 VDD
GND 2
SOT23
(Top View)
3. OUTPUT
2. GND
VDD
The single open-drain output can be switched on with south or north
pole of sufficient strength. When the magnetic flux density (B)
perpendicular to the package is larger than the operate point (BOP),
the output is switched on (pulled low) and is held on until the
magnetic flux density B is lower than the release point (BRP).
1.
SIP-3 (Bulk Pack)
Applications
Features
Omnipolar Operation
•
•
•
•
•
•
•
•
Position and Proximity Sensing in Automotive Applications
•
•
•
•
High Sensitivity: BOP and BRP of ±30G and ±20G Typical
Internally Pull-up Resistor on the Output with Overcurrent Limit
3.0V to 28V Operating Voltage Range
Open and Close Detect
Position Detect
Level Detect
Chopper Stabilized Design Provides
Flow Meters
o
o
o
Superior Temperature Stability
Minimal Switch Point Drift
Contactless Switches
Seatbelt Buckle
Seat Position
Enhanced Immunity to Stress
•
•
•
•
•
•
Good RF Noise Immunity
Reverse Blocking Diode
Zener Clamp on Supply and Output Pins
-40°C to +150°C Operating Temperature
ESD: HBM > 8kV, CDM: > 2kV
Industry Standard SOT23 and SIP-3 (Ammo Pack), SIP-3 (Bulk
Pack) Packages
•
Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
Halogen and Antimony Free. “Green” Device (Note 3)
•
Notes:
1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS), 2011/65/EU (RoHS 2) & 2015/863/EU (RoHS 3) compliant.
2. See https://www.diodes.com/quality/lead-free/ for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green" and
Lead-free.
3. Halogen- and Antimony-free "Green” products are defined as those which contain <900ppm bromine, <900ppm chlorine (<1500ppm total Br + Cl) and
<1000ppm antimony compounds.
1 of 14
www.diodes.com
July 2018
© Diodes Incorporated
AH3563Q
Document number: DS40865 Rev. 1 - 2