ADuM7703
Data Sheet
V
1
2
3
4
8
7
6
5
V
DD2
DD1
V
ADuM7703
MCLKIN
MDAT
IN+
TOP VIEW
V
IN–
(Not to Scale)
GND
GND
2
1
NOTES
1. CONNECT GND BEFORE V
.
DD1
1
Figure 6. 8-Lead SOIC_IC Pin Configuration
Table 12. 8-Lead SOIC_IC Pin Function Descriptions
Pin No.
Mnemonic Description
1
VDD1
Supply Voltage, 4.± V to 20 V. This pin is the supply voltage for the isolated side of the ADuM7703 and is relative to
GND1. For device operation, connect the VDD1 supply voltage to the VDD1 pin. Decouple the supply pin to GND1 with
a 10 μF capacitor in parallel with a 100 nF capacitor as close to the pin as possible.
2
3
4
±
6
VIN+
VIN−
GND1
GND2
MDAT
Positive Analog Input.
Negative Analog Input.
Ground 1. This pin is the ground reference point for all circuitry on the isolated side.
Ground 2. This pin is the ground reference point for all circuitry on the nonisolated side.
Serial Data Output. The single-bit modulator output is supplied to this pin as a serial data stream. The bits are
clocked out on the rising edge of the MCLKIN input and are valid on the following MCLKIN rising edge.
7
ꢀ
MCLKIN
VDD2
Master Clock Logic Input, ± MHz to 21 MHz frequency range. The bit stream from the modulator is propagated on
the rising edge of the MCLKIN.
Supply Voltage, 3 V or ±.± V. This pin is the supply voltage for the nonisolated side and is relative to GND2.
Decouple this supply to GND2 with a 10 μF capacitor in parallel with a 100 nF capacitor as close to the pin as possible.
Rev. 0 | Page 10 of 22