3 A, Low VIN, Low Noise,
CMOS Linear Regulator
ADP1763
Data Sheet
FEATURES
TYPICAL APPLICATION CIRCUITS
3 A maximum output current
Low input voltage supply range
ADP1763
V
= 1.5V
V
= 1.8V
OUT
IN
VIN
VOUT
SENSE
EN
C
10µF
C
OUT
10µF
IN
VIN = 1.10 V to 1.98 V, no external bias supply required
R
ON
PULL-UP
Fixed output voltage range: VOUT_FIXED = 0.9 V to 1.5 V
Adjustable output voltage range: VOUT_ADJ = 0.5 V to 1.5 V
Ultralow noise: 2 μV rms, 100 Hz to 100 kHz
Noise spectral density
100kΩ
OFF
PG
PG
SS
VADJ
C
SS
VREG
REFCAP
10nF
C
C
1µF
REF
1µF
GND
REG
4 nV/√Hz at 10 kHz
3 nV/√Hz at 100 kHz
Figure 1. Fixed Output Operation
Low dropout voltage: 95 mV typical at 3 A load
Operating supply current: 4.5 mA typical at no load
1.5ꢀ fixed output voltage accuracy over line, load, and
temperature
Excellent power supply rejection ratio (PSRR) performance
59 dB typical at 10 kHz at 3 A load
43 dB typical at 100 kHz at 3 A load
Excellent load/line transient response
Soft start to reduce inrush current
Optimized for small 10 μF ceramic capacitors
Current-limit and thermal overload protection
Power-good indicator
ADP1763
V
= 1.8V
R
V
= 1.5V
C
OUT
IN
OUT
VIN
VOUT
C
10µF
IN
10µF
SENSE
ON
PULL-UP
100kΩ
EN
OFF
PG
PG
SS
VADJ
C
R
VREG
REFCAP
SS
ADJ
10nF
10kΩ
C
C
REF
REG
1µF
GND
1µF
Figure 2. Adjustable Output Operation
Precision enable
16-lead, 3 mm × 3 mm LFCSP package
APPLICATIONS
Table 1. Related Devices
Input
Voltage Current
Maximum Fixed/
Regulation to noise sensitive applications such as radio
frequency (RF) transceivers, analog-to-digital converter
(ADC) and digital-to-analog converter (DAC) circuits,
phase-locked loops (PLLs), voltage controlled oscillators
(VCOs) and clocking integrated circuits
Field-programmable gate array (FPGA) and digital signal
processor (DSP) supplies
Medical and healthcare
Device
Adjustable
Package
ADP1761 1.10 V to 1 A
1.98 V
ADP1762 1.10 V to 2 A
1.98 V
ADP1740/ 1.6 V to
ADP1741 3.6 V
ADP1752/ 1.6 V to
ADP1753 3.6 V
Fixed/adjustable 16-lead
LFCSP
Fixed/adjustable 16-lead
LFCSP
2 A
Fixed/adjustable 16-lead
LFCSP
0.8 A
1.2 A
Fixed/adjustable 16-lead
LFCSP
Fixed/adjustable 16-lead
LFCSP
Industrial and instrumentation
ADP1754/ 1.6 V to
ADP1755 3.6 V
GENERAL DESCRIPTION
The ADP1763 is a low noise, low dropout (LDO) linear regulator. It
is designed to operate from a single input supply with an input
voltage as low as 1.10 V without the requirement of an external bias
supply to increase efficiency and provide up to 3 A of output current.
The ADP1763 is available in fixed output voltages ranging from
0.9 V to 1.5 V. The output of the adjustable output model can be
set from 0.5 V to 1.5 V through an external resistor connected
between VADJ and ground.
The low 95 mV typical dropout voltage at a 3 A load allows the
ADP1763 to operate with a small headroom while maintaining
regulation and providing better efficiency.
The ADP1763 has an externally programmable soft start time by
connecting a capacitor to the SS pin. Short-circuit and thermal
overload protection circuits prevent damage in adverse conditions.
The ADP1763 is available in a small 16-lead LFCSP package for the
smallest footprint solution to meet a variety of applications.
The ADP1763 is optimized for stable operation with small 10 μF
ceramic output capacitors. The ADP1763 delivers optimal
transient performance with minimal board area.
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Technical Support
©2016 Analog Devices, Inc. All rights reserved.
www.analog.com