8-Channel Fault-Protected
Analog Multiplexer
ADG528F
FUNCTIONAL BLOCK DIAGRAM
FEATURES
Low on resistance (300 Ω typical)
Fast switching times
ADG528F
t
t
ON: 250 ns maximum
OFF: 250 ns maximum
S1
Low power dissipation (3.3 mW maximum)
Fault and overvoltage protection (−40 V to +55 V)
All switches off with power supply off
Analog output of on channel clamped within power
supplies if an overvoltage occurs
D
S8
Latch-up proof construction
Break-before-make construction
WR
RS
1 OF 8
DECODER
TTL and CMOS compatible inputs
A0 A1 A2 EN
APPLICATIONS
Figure 1.
Existing multiplexer applications (both fault-protected and
nonfault-protected)
New designs requiring multiplexer functions
GENERAL DESCRIPTION
PRODUCT HIGHLIGHTS
The ADG528F1 is a CMOS analog multiplexer, with the
comprising eight single channels. This multiplexer provides
fault protection. Using a series n-channel, p-channel, n-channel
MOSFET structure, both device and signal source protection is
provided in the event of an overvoltage or power loss. The
multiplexer can withstand continuous overvoltage inputs
from −40 V to +55 V. During fault conditions, the multiplexer
input (or output) appears as an open circuit and only a few
nanoamperes of leakage current will flow. This protects not
only the multiplexer and the circuitry driven by the multiplexer,
but also protects the sensors or signal sources that drive the
multiplexer.
1. Fault protection.
The ADG528F can withstand continuous voltage inputs
from −40 V to +55 V. When a fault occurs due to the
power supplies being turned off, all the channels are turned
off and only a leakage current of a few nanoamperes flows.
2. On channel turns off while fault exists.
3. Low RON
.
4. Fast switching times.
5. Break-before-make switching.
Switches are guaranteed break-before-make so that input
signals are protected against momentary shorting.
6. Trench isolation eliminates latch-up.
A dielectric trench separates the p-channel and n-channel
MOSFETs thereby preventing latch-up.
The ADG528F switches one of eight inputs to a common output
as determined by the 3-bit binary address lines A0, A1, and A2.
The ADG528F has on-chip address and control latches that
facilitate microprocessor interfacing. An EN input on the device
is used to enable or disable the device. When disabled, all channels
are switched off.
Rev. F
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113 ©2001–2011 Analog Devices, Inc. All rights reserved.