16-Bit, 1600 MSPS, TxDAC+ Digital-to-
Analog Converter
Data Sheet
AD9139
FEATURES
GENERAL DESCRIPTION
Selectable 1× or 2× interpolation filter
Support input signal bandwidth up to 575 MHz
The AD9139 is an 16-bit, high dynamic range digital-to-analog
converter (DAC) that provides a sample rate of 1600 MSPS,
Very small inherent latency variation: <2 DAC clock cycles
Proprietary low spurious and distortion design
6-carrier GSM ACLR = 79 dBc at 200 MHz IF
SFDR >85 dBc (bandwidth = 300 MHz) at zero IF
Flexible 16-bit LVDS interface
Supports word and byte load
Multiple chip synchronization
Fixed latency and data generator latency compensation
FIFO eases system timing and includes error detection
High performance, low noise PLL clock multiplier
Digital inverse sinc filter
permitting a multicarrier generation up to the Nyquist frequency.
The AD9139 TxDAC+® includes features optimized for wideband
communication applications, including 1× and 2× interpolation, a
delay locked loop (DLL) powered high speed interface, sample
error detection, and parity detection. A 3-wire serial port
interface provides for the programming/readback of many
internal parameters. A full-scale output current can be
programmed over a range of 9 mA up to 33 mA. The AD9139 is
available in a 72-lead LFCSP.
PRODUCT HIGHLIGHTS
1. 575 MHz achievable input signal bandwidth.
2. Advanced low spurious and distortion design techniques
provide high quality synthesis of wideband signals from
baseband to high intermediate frequencies.
3. Very small inherent latency variation simplifies both software
and hardware design in the system. It allows easy multichip
synchronization for most applications.
Low power: 700 mW at 1230 MSPS
72-lead LFCSP
APPLICATIONS
Wireless communications: 3G/4G and MC-GSM base stations,
wideband repeaters, software defined radios
Wideband communications: point-to-point, LMDS/MMDS
Transmit diversity/MIMO
4. Low power architecture improves power efficiency.
Instrumentation
Automated test equipment
FUNCTIONAL BLOCK DIAGRAM
DLL
13-TAP
DCIP/DCIN
D15P/D15N
D0P/D0N
AD9139
16
DACOUTP
DAC 1
16-BIT
DACOUTN
HB1
2×
DAC_CLK
FRAMEP/PARITYP
FRAMEN/PARITYN
REF
AND
BIAS
VREF
10
FSADJ
INTERNAL CLOCK TIMING AND CONTROL LOGIC
DACCLKP
DACCLKN
PROGRAMMING
REGISTERS
SERIAL
INPUT/OUTPUT
PORT
CLK
RCVR
POWER-ON
RESET
MULTICHIP
SYNCHRONIZATION
DAC_CLK
REFP/SYNCP
REFN/SYNCN
CLOCK
MULTIPLIER
REF
RCVR
SYNC
Figure 1.
Rev. 0
Document Feedback
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
©2013 Analog Devices, Inc. All rights reserved.
Technical Support
www.analog.com