A29001/290011 Series
128K X 8 Bit CMOS 5.0 Volt-only,
Boot Sector Flash Memory
Preliminary
Features
nTypical 100,000 program/erase cycles per sector
n20-year data retention at 125°C
n5.0V ± 10% for read and write operations
nAccess times:
- 55/70/90 (max.)
nCurrent:
- Reliable operation for the life of the system
nCompatible with JEDEC-standards
- 20 mA typical active read current
- 30 mA typical program/erase current
- 1 mA typical CMOS standby
- Pinout and software compatible with single-power-
supply Flash memory standard
- Superior inadvertent write protection
nFlexible sector architecture
n
Polling and toggle bits
- Provides a software method of detecting completion of
program or erase operations
Data
- 8 Kbyte/ 4 KbyteX2/ 16 Kbyte/ 32 KbyteX3 sectors
- Any combination of sectors can be erased
- Supports full chip erase
nErase Suspend/Erase Resume
- Sector protection:
- Suspends a sector erase operation to read data from,
or program data to, a non-erasing sector, then
resumes the erase operation
A hardware method of protecting sectors to prevent
any inadvertent program or erase operations within
that sector
nHardware reset pin (
)
RESET
nTop or bottom boot block configurations available
nEmbedded Erase Algorithms
- Hardware method to reset the device to reading array
data (not available on A290011)
- Embedded Erase algorithm will automatically erase the
entire chip or any combination of designated sectors
and verify the erased sectors
nPackage options
- 32-pin P-DIP, PLCC, or TSOP (Forward type)
- Embedded Program algorithm automatically writes and
verifies bytes at specified addresses
General Description
The device requires only a single 5.0 volt power supply for both
read and write functions. Internally generated and regulated
voltages are provided for the program and erase operations.
The A29001 is entirely software command set compatible with
the JEDEC single-power-supply Flash standard. Commands
are written to the command register using standard
microprocessor write timings. Register contents serve as input
to an internal state-machine that controls the erase and
programming circuitry. Write cycles also internally latch
addresses and data needed for the programming and erase
operations. Reading data out of the device is similar to reading
from other Flash or EPROM devices.
Device programming occurs by writing the proper program
command sequence. This initiates the Embedded Program
algorithm - an internal algorithm that automatically times the
program pulse widths and verifies proper program margin.
Device erasure occurs by executing the proper erase
command sequence. This initiates the Embedded Erase
The A29001 is a 5.0 volt-only Flash memory organized as
131,072 bytes of 8 bits each. The A29001 offers the
RESET
function, but it is not available on A290011. The 128 Kbytes of
data are further divided into seven sectors for flexible sector
erase capability. The 8 bits of data appear on I/O0 - I/O7 while
the addresses are input on A0 to A16. The A29001 is offered in
32-pin PLCC, TSOP, and PDIP packages. This device is
designed to be programmed in-system with the standard
system 5.0 volt VCC supply. Additional 12.0 volt VPP is not
required for in-system write or erase operations. However, the
A29001 can also be programmed in standard EPROM
programmers.
The A29001 has the first toggle bit, I/O6, which indicates
whether an Embedded Program or Erase is in progress, or it is
in the Erase Suspend. Besides the I/O6 toggle bit, the A29001
has a second toggle bit, I/O2, to indicate whether the
addressed sector is being selected for erase. The A29001 also
offers the ability to program in the Erase Suspend mode. The
standard A29001 offers access times of 55, 70 and 90 ns
allowing high-speed microprocessors to operate without wait
states. To eliminate bus contention the device has separate
algorithm
-
an internal algorithm that automatically
preprograms the array (if it is not already programmed) before
executing the erase operation. During erase, the device
automatically times the erase pulse widths and verifies proper
erase margin.
chip enable (
controls.
), write enable (
) and output enable (
)
OE
CE
WE
PRELIMINARY
(August, 2001, Version 0.3)
1
AMIC Technology, Inc.
5秒后页面跳转
英伟达新AI芯片Rubin或提前半年亮相
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
三星深化印度制造布局，供应链本地化进程加速
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
