2557
PROTECTED QUAD LOW-SIDE DRIVER
WITH FAULT DETECTION & SLEEP MODE
The A2557xB, A2557xEB, and A2557xLB have been specifically
designed to provide cost-effective solutions to relay-driving applications with
up to 300 mA drive current per channel. They may also be used for driving
incandescent lamps in applications where turn-on time is not a concern. Each
of the four outputs will sink 300 mA in the on state. The outputs have a
minimum breakdown voltage of 60 V and a sustaining voltage of 40 V. A
low-power Sleep Mode is activated with either ENABLE low or all inputs
low. In this mode, the supply current drops to below 100 µA.
Over-current protection for each channel has been designed into these
devices and is activated at a nominal 500 mA. It protects each output from
short circuits with supply voltages up to 32 V. When an output experiences a
short circuit, the output current is limited at the 500 mA current clamp. In
addition, foldback circuitry decreases the current limit if an excessive voltage
is present across the output and assists in keeping the device within its SOA
(safe operating area). An exclusive-OR circuit compares the input and output
state of each driver. If either a short or open load condition is detected, a
single FAULT output is turned on (active low). Similar devices, for operation
to 1.3 A, are available as the UDx2547B/EB.
A2557xLB
1
2
3
4
16
IN
IN
OUT
1
2
1
15
14
K
ENABLE
GROUND
GROUND
OUT
2
13
12
11
10
9
GROUND
5
6
GROUND
OUT
3
V
CC
7
8
FAULT
OUT
IN
IN
3
4
4
Continuous or multiple overload conditions causing the channel tempera-
ture to reach approximately 165°C will result in an additional linear decrease
in the output current of the affected driver. If the fault condition is corrected,
the output stage will return to its normal saturated condition.
Dwg. PP-017-4
Note that the A2557xB (DIP) and the A2557xLB
(SOIC) are electrically identical and share a
common terminal number assignment.
The first character of the part number suffix determines the device
operating temperature range. Suffix ‘S-’ is the standard -20°C to +85°C;
suffix ‘E-’ is -40°C to +85°C; suffix ‘K-’ is for the industrial temperature
range of -40°C to +125°C. Package suffix ‘-B’ devices are 16-pin power
DIPs; suffix ‘-EB’ devices are 28-lead power PLCCs; and suffix ‘-LB’ are 16-
lead power wide-body SOICs for surface-mount applications. All packages
are of batwing construction to provide for maximum package power dissipa-
tion.
ABSOLUTE MAXIMUM RATINGS
Output Voltage, VO .............................. 60 V
Over-Current Protected Output Voltage,
VO ..................................................... 32 V
Output Current, IO ......................... 500 mA*
FAULT Output Voltage, VFLT ............. 60 V
Logic Supply Voltage, VCC ................. 7.0 V
Input Voltage, VI or VOE ..................... 7.0 V
Package Power Dissipation,
PD ........................................... See Graph
Operating Temperature Range, TA
Suffix ‘S-’ ...................... -20°C to +85°C
Suffix ‘E-’ ...................... -40°C to +85°C
Suffix ‘K-’ ................... -40°C to +125°C
Junction Temperature,
FEATURES
I 300 mA Output Current per Channel
I Independent Over-Current Protection &Thermal Limiting for Each Driver
I Output Voltage to 60 V
I Output SOA Protection
I Fault-Detection Circuitry for Open or Shorted Load
I Low Quiescent Current Sleep Mode
I Integral Output Flyback/Clamp Diodes
I TTL- and 5 V CMOS-Compatible Inputs
TJ ............................................... +150°C*
Storage Temperature Range,
TS ................................. -55°C to +150°C
*Outputs are current limited at approximately
500 mA per driver and junction temperature
limited if higher current is attempted.
Complete part number includes a suffix to identify operating temperature
range (E-, K-, or S-) and package type (-B, -EB, or -LB). Always order by
complete part number, e.g., A2557KLB .
5秒后页面跳转
英伟达新AI芯片Rubin或提前半年亮相
苹果iPhone 17将全系采用三星/LG显示LTPO OLED面板
三星深化印度制造布局，供应链本地化进程加速
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
