A1369
Customer Programmable Linear Hall-Effect Sensor
Optimized for Use in Current Sensing Applications
DESCRIPTION
FEATURES AND BENEFITS
• Customer programmable offset, and sensitivity
• Sensitivity & QVO temperature coefficients programmed
at Allegro for improved accuracy
• Output value decreases with South Magnetic Field and
increases with North Magnetic field.
• 3-pin SIP package for easy integration with magnetic
concentrator
The Allegro™ A1369 is a customer programmable, high
accuracy linear Hall effect-based current sensor IC. It is
packagedinathin3-pinSIPpackagetoallowforeasyintegration
withamagneticcoretocreateahighlyaccuratecurrentsensing
module. The programmable nature of the A1369 enables it
to account for manufacturing tolerances in the final current
sensing module assembly.
• Low noise, moderate bandwidth, analog output
• High speed chopping scheme minimizes QVO drift over
temperature
• Temperature-stable quiescent voltage output and
sensitivity
• Precise recoverability after temperature cycling
• Output voltage clamps provide short circuit diagnostic
capabilities
This temperature-stable device is available in a through-hole
single in-line package (TO-92). The accuracy of the device
is enhanced via programmability on the output pin for end-
of-line optimization without the added complexity and cost of
a fully programmable device. The device features One-Time-
Programming (OTP), using non-volatile memory, to optimize
device sensitivity and the quiescent output voltage (QVO)
(output with no magnetic field) for a given application or
circuit. TheA1369 also allow for optimized performance over
temperaturethroughprogrammingthetemperaturecoefficient
for both Sensitivity and QVO at Allegro end of line test.
• Under voltage lock-out (UVLO)
Continued on the next page…
Package: 3-Pin SIP (suffix UA)
These ratiometric Hall effect sensor ICs provide a voltage
output that is proportional to the applied magnetic field. The
quiescent voltage output is user adjustable around 50% of the
supply voltage and the output sensitivity is programmable
within a range of 8.5 mV/G to 12.5 mV/G for the A1369-10
and 22 mV/G to 26 mV/G for the A1369-24.
Not to scale
Continued on the next page…
V+
VCC
VOUT/
Programming
Sensitivity and
Sensitivity TC
Offset and
Offset TC
Trim Control
GND
Functional Block Drawing
A1369-DS, Rev. 1