IDT71P73204
IDT71P73104
IDT71P73804
IDT71P73604
18Mb Pipelined
DDR™II SRAM
Burst of 4
Features
Description
The IDT DDRIITM Burst of four SRAMs are high-speed synchro-
nous memories with a double-data-rate (DDR), bidirectional data port.
This scheme allows maximization on the bandwidth on the data bus by
passing two data items per clock cycle. The address bus operates at
less than single data rate speeds,allowing the user to fan out addresses
and ease system design while maintaining maximum performance on
data transfers.
◆
◆
◆
◆
◆
18Mb Density (2Mx8, 2Mx9, 1Mx18, 512Kx36)
Common Read and Write Data Port
Dual Echo Clock Output
4-Word Burst on all SRAM accesses
MultiplexedAddress Bus
-
One Read or One Write request per two clock
cycles.
DDR (Double Data Rate) Data Bus
Four word bursts data per two clock cycles
The DDRII has scalable output impedance on its data output bus
and echo clocks, allowing the user to tune the bus for low noise and high
performance.
◆
-
◆
◆
Depth expansion through Control Logic
HSTL (1.5V) inputs that can be scaled to receive signals
from 1.4V to 1.9V.
All interfaces of the DDRII SRAM are HSTL, allowing speeds
beyond SRAM devices that use any form of TTL interface. The inter-
face can be scaled to higher voltages (up to 1.9V) to interface with 1.8V
systems if necessary. The device has a VDDQ and a separate Vref,
allowing the user to designate the interface operational voltage, inde-
pendent of the device core voltage of 1.8V VDD. Theoutput impedance
control allows the user to adjust the drive strength to adapt to a wide
range of loads and transmission lines.
◆
Scalable output drivers
-
Can drive HSTL, 1.8V TTL or any voltage level
from 1.4V to 1.9V.
Output Impedance adjustable from 35 ohms to 70
ohms
-
◆
1.8V Core Voltage (VDD)
◆
JTAG Interface
◆
165-ball, 1.0mm pitch, 13mm x 15mm fBGA Package
Functional Block Diagram
DATA
REG
(Note1)
WRITE DRIVER
(Note2)
SA
ADD
REG
(Note2)
SA0
SA
1
(Note4)
(Note4)
(Note1)
18M
MEMORY
ARRAY
DQ
LD
RW
BWx
CTRL
LOGIC
(Note3)
K
K
CLK
GEN
CQ
CQ
C
SELECT OUTPUT CONTROL
C
6431 drw 16
Notes
1) Represents 8 data signal lines for x8, 9 signal lines for x9, 18 signal lines for x18, and 36 signal lines for x36
2) Represents 19 address signal lines for x8 and x9, 20 address signal lines for x18, and 19 address signal lines for x36.
3) Represents 1 signal line for x9, 2 signal lines for x18, and four signal lines for x36. On x8 parts, the BW is a “nibble write” and there are 2
signal lines.
4) Represents 16 data signal lines for x8, 18 signal lines for x9, 36 signal lines for x18, and 72 signal lines for x36.
JULY 2005
1
©2005 Integrated Device Technology, Inc. “QDR SRAMs and Quad Data Rate RAMs comprise a new family of products developed by Cypress Semiconductor, IDT, and Micron Technology, Inc.“
DSC-6431/00